Question about 2007 Ford Edge SEL Plus

1 Answer

How do I change the return hose for the power steering on my 2007 ford edge?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 22 Answers

Remove fluid from power steering res and disconnect the return hose jack front of vehicle up high enough to get behind engine to firewall the powersteering unit is located there place jack stands under vehicle for safety then get under vehicle to remove hose from powersteering unit, observe routing of hose to replace new hose

Posted on Nov 21, 2018

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
junkman1249

Ricardo Loranca

  • 552 Answers

SOURCE: hoses are leaking

one at a time. after you install them make sure you turn the car on and move the steering wheel left to right several times to let the fluid circulate into the pump. you hear a strange noise but it will go away

Posted on Dec 13, 2008

michigan man

edgar walker

  • 3533 Answers

SOURCE: 2007 ford edge, three lights are on: ABS, wrench

it sound like a ABS-sensor is sticking are its bad give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car wish you the best of luck Michigan Man.

Posted on Jan 12, 2010

wireguy212

danny herget

  • 1627 Answers

SOURCE: 2007 edge has windshield washer sprayer hose broken

You can pick up new splices or tee's at any parts store out of their repair kit,just take one with you when you go for reference.

Posted on Jan 28, 2010

troyolsen

  • 1 Answer

SOURCE: power steering pump return hose from steering box

1999 F250 diesel. POwer steering fluid "pours" out of the trk when the steering wheel is turned. Does not leak when at rest, fluid coming out between the steering box and frame....is the a hose inbetween there or is it a possible cracked box (bolts are tight on frame)

Posted on Jan 10, 2011

Anonymous

SOURCE: THROTTLE POSITION SENSOR ON A 2007 FORD EDGE

Doubt it failed----did you test it with a volt meter,put
an oscilloscope on it,or look at scan tool data


Have a couple T20 Torx Screws that hold it on

You heat them with a hair dryer to soften the
Blue Thread Locker

Why not tell us the vehicles problems & what you tested so far

Posted on Aug 31, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power steering pump 2007 Ford Edge located where? Can't seem to locate it..need to replace it; 3.5 engine


CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power steering components may result.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02 .
  1. Using a suitable suction device, siphon the power steering fluid from the power steering fluid reservoir.
  1. Remove the RH inner fender splash shield. For additional information, refer to Section 501-02 .
  1. Using the special tool, disengage the power steering pump belt from the power steering pump pulley and position it aside.
    • Install the removal tool between the belt and the pulley and turn the crankshaft bolt clockwise to disengage the belt.
  1. Remove the 4 bolts and position the driveshaft aside.
  1. Using a suitable jack, support the rear of the subframe.
  1. Remove the 2 nuts, 4 bolts and the subframe support brackets.
  1. Remove the 2 middle subframe nuts.
  1. Lower the rear of the subframe.
  1. Release the clamp and disconnect the power steering supply hose from the power steering pump.
  1. Disconnect the power steering pressure (PSP) switch electrical connector.
  1. Remove the power steering pressure line fitting banjo bolt and disconnect the line from the power steering pump.
    • Discard the 2 seals.
  1. Remove the 3 power steering pump bolts and the power steering pump. This is a job best left to a qualified repair shop !

Jul 26, 2016 | 2007 Ford Edge

2 Answers

How to drain power steering fluid on 2007 pontiac g6


The 2007 Pontiac G6 does not have power steering fluid. It has electric power assisted steering. No power steering fluid to ever have to change.

May 02, 2015 | 2007 Pontiac G6

1 Answer

How to repair power steering leak?


You need to first diagnose what is leaking. Most power steering leaks are in the pressure hose but not always. Pressure hoses will have screw on fittings and return hoses will usually just have spring clamps or screw type clamps on the end of the hose. Pressure hose most likely, return hoses 2nd, failing rack and pinion assy 3rd and pressure pump last. If its leaking from the bellows on the end of the rack and pinion the you will need a reman unit. Presure pumps are also remanufactured if thats what you need. hoses are replaced with new hoses or standard return hose for the return line.

Jul 12, 2014 | 2001 Ford Windstar

2 Answers

98 Ford power steering keeks bursting the high pressure hose.


it sounds like it is pumping too much pressure, you need to take the vehicle to a power steering specialist & have the pressure adjusted otherwise you will just keep bursting hoses or the seals on the steering rack......hope this helps.....cheers.

Jun 28, 2011 | 1998 Ford Windstar

1 Answer

Change the power steering pump


Remove cap, remove return hose, drain fluid, loosen pump,

You can go to autozone dot com and register for free for a free online repair manual for your vehicle.

Mar 19, 2010 | 2004 Ford Taurus

1 Answer

High pressure power steering hose - one or two?


Here is a pic.

[IMG]http://i253.photobucket.com/albums/hh43/chuck943/DG1690A.gif[/IMG]



1 3A674 Power Steering Pump 2 3A714 Power Steering Pressure Hose 3 3C510 Power Steering Hose Bracket 4 3N824 Power Steering Pressure Switch 5 3504 Steering Gear 6 3A713 Power Steering Return Hose (Gear to Cooler) 7 3D746 Power Steering Fluid Cooler 8 3493 Power Steering Return Hose (Cooler to Pump

Feb 23, 2009 | 1999 Ford Taurus

1 Answer

2007 chevy impala


Pricing vary, depending on where you live and if you want it done at a dealership or at a local shop.It would be about 1hour of labor +price of the hose+power steering fluid. Dealer charges about $70.00 an hour.
You can call the dealer ask how much to change the hose. Also a local shop can gave you an estimate.

Jul 29, 2008 | 2007 Chevrolet Impala LS Sedan New Cars

Not finding what you are looking for?
2007 Ford Edge SEL Plus Logo

410 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...