Torque specs 2003 olds silhouette rocker arm 3.400

Question edited for clarity.
Question moved to Category.

Torque and sequence

https://www.2carpros.com/questions/rocker-arm-assembly-torque-specs

Cam Belt Timing

https://www.google.com/search?q=2003+Mitsubishi+Eclipse+GS.+Cam+belt+timing

..

Says here

https://www.2carpros.com/questions/sequence-to-tighten-head-bolts-and-rocker-arms-also-torque-specs

https://www.google.com/search?q=torque+spec+for+a+2003+Pontiac+Grand+AM+3.4+head+gasket+bolts

..

you need service and repair manual to do the torque setting so go to the given link and get the manual http://toolsnyou.com/

14 N.m (124 lb. in.) plus 30° This what the book says. But 10 foot pounds plus 30 degrees.

Oldsmobile Torque Specs - GbodyOlds.com

www.gbodyolds.com/forum/showthread.php?754-Oldsmobile-Torque...
Feb 7, 2013 - 2 posts - ‎2 authors Oldsmobile Small-Block Engines Cylinder Head Bolts (1/2in. bolt) 130 ft. lbs. Cylinder Head ... Rocker Arm Pivot Bolt 25 ft. lbs. Rod Bearing ...

Rocker Arms - AutoZone

www.autozone.com/...Cutlass...1987.../Rocker-Arms/_/P-0900...

AutoZoneGM Cutlass RWD 1970-1987 Repair Guide ... To remove the rocker arms from the shaft, the nylon arm retainers must be removed. ... 7: Engine valve system, 260, 307, 350, 403 Oldsmobile built engines ... Unfasten the two bolts that attach the rocker arm pivot to the cylinder head. ... Torque the retaining bolts to 25 ft. lbs.

Tighten the bearing cap in two or three steps. Tighten it to the standard torque at the last stage. *Bearing cap standard torque Torque16 pieces at the both ends : 18.6 - 20.6 N·m(190 - 210kg·cm, 13.7 - 15.2 lb·ft)24

I would call a dealer and ask to talk to a teck

You don't. They are non-adjustable hydraulic lifters. GM's spec for torque on the rocker arm nuts: Tighten the valve rocker arm ball studs to 47 N·m (35 lb ft). Once the valve rocker arm nuts are installed and properly torqued, no additional valve lash adjustment is required.

I presume that you are connecting your Intake manifold to the cylinder head after replacing your intake gasket, if so they are 30ft lbs, and 360 in pounds. Hope that helps

Torque: 210 @ 4000 rpm