Where is the speed sensor located on a 2005 toyota tacoma on the tranny...can you send me pics please

https://www.google.com/search?q=2005+tacoma+vss+A+location

TOYOTA TACOMA SERVICE REPAIR MANUAL 1999 2000 2001 2002 2003 2004 2005...


for the easy solution download the pdf file

This is the 2001-2012 Toyota Tacoma wiring diagram, Toyota Tacoma IAT (Intake Air Temperature) Sensor Location and the Toyota Tacoma MAF (Mass Air Flow) Sensor Location, also included is a pinout of the sensor. You are likely installing a performance chip or a cold air intake kit for increased HP (Horsepower). You will want to be sure to disconnect the car battery before adding performance products.




Here is the Toyota Tacoma's Iat sensor diagram:

On the early Tacoma, the speed sensor is located in the cluster and is driven by a cable attached to the transmission.
Later models moved the sensor to the transmission tailshaft or transfer case and eliminated the cable.
If you do not have a speedometer cable, your sensor is on the transmission.

The speed sensor is located on the outside of the transmission case, it has a wire connector going to it. There are other sensors called turbine speed sensors and they are located inside the transmission. It all depends on what problem you have.

A 1997 toyota doesnt have a cable but rather it uses a speed sensor, this is located at the rear of the tranny, that would mostlikely be the problem, unless this is the wrong year and then it may have a cable and the cable comes complete inner and outer covering, good day.

It is mounted in the transmission bellhousing. If you can follow the engine control computer wires, they will lead you to the side of the bellhousing that the crankshaft sensor is on. If you have purchased the sensor, then it will be easy to spot as you will have an idea of what you are looking for.

only one speed sensor it is in the back side top of the tranny has a 10mm bolt holding it in about $44

REPLACEMENT

HINT: The replacement procedures for the RH side are the same as those for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE SPEED SENSOR REAR LH
1. Disconnect the speed sensor connector.
2. Remove the nut and speed sensor rear. NOTICE:
• Do not attach any foreign matter to the sensor tip.
• Ensure that no foreign matter enters the sensor installation hole.
1. INSTALL SPEED SENSOR REAR LH
1. Install the rear speed sensor with the nut. Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.) NOTICE: Make sure that the sensor tip is clean.
2. Connect the speed sensor connector.
1. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Torque: 3.9 Nm (40 kgf-cm, 35 inch lbs.)
2. CHECK ABS SENSOR SIGNAL

It is definitely the speed sensor assembly which hangs outside the transmission underneath the truck. Usually runs a little over $110