How do I remove and replace drivers side power window switch 2002 olds silouette

SOURCE: Remove door trim to replace power window switch

you dont have to take the trrim off on this car look at the outline of the switch open from rear and pull forward then you can change the window switch/ Please rate my response thank you very much

SOURCE: How to remove/replace driver's side mirror on 96 blazer

remove door panel.. there should be access hole to get to the bolts.

SOURCE: How to remove interior door panel on 2002 chrysler t & c???

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

justin Jensen

• 90 Answers
• Posted on Sep 28, 2009

SOURCE: replace driver side power window motor

Once you have removed the inner door panel you unbolt the motor and regulator (They should come togther) and install.

SOURCE: 2003 Lincoln Town Car - Power window switch removal/installation

SECTION 501-05: Interior Trim and Ornamentation 2003 Town Car Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 01/28/2002 Front Door Trim Panel Printable View (206 KB) Removal and Installation
NOTE: LH side shown, RH side similar.

1. Disconnect the battery ground cable. For additional information, refer to Section 414-01.

1. Remove the window switch plate.

1. Disconnect the electrical connectors.

1. CAUTION: Use care not to damage the trim panel covers.
   Open the screw covers.

1. Remove the screws and the assist handle.

1. Remove screws and the front door trim.

1. Disconnect the electrical connectors.

1. To install, reverse the removal procedure.