How can i fix faulty signal flashing in my mitsubishi colt 1.3

Where is the inertia switch of the Mitsubishi Colt located?

https://www.scegliauto.com > domanderisposte
Oct 24, 2021 - The inertia switch is a safety system which, in the event of an accident, cuts off the flow of fuel to the engine in order to avoid possible ...
Missing: Plus ‎emergency

inertia switch - Mitsubishi Forum

https://mitsubishiforum.com > ... > 2nd Generation
There shouldn't be a manual switch for the fuel pump or an ASD type switch that turns off the injectors and cuts the timing signal. The only way you would have ...

speed sensor located in the transmission ---

for better result download the pdf file
MITSUBISHI COLT COLT RALLIART 2003 2010 WORKSHOP MANUAL

If you mean turn signal flasher, look at fuse box.

When the indicators flash 9 times when locking/unlocking the car it means the battery in the key is running low. Change the battery in the key, it's probably a CR2016.

Lights are flashing, if flash is not bad.auto diagnostic tool

Room lights have connection with the door switches as well push buttons built inside the light. So if any of the switches is not working then the light would not go off. This problem can be identified by checking your door open light in the meter panel. If it remains on then you need to detect and replace that switch. In order to detect that which switch is faulty, you open door one by one and press its on/off switch and observe if the door light in meter goes off. If it does then you need to replace that faulty switch.

You should also push light itself and you will feel its on/off push buttons.

P1936 is a Clutch Switch/ Sensor Signal problem.
Hope this helps you solve the problem. 

bad CV joints?

could be turn signal relay or one of the bulbs is bad that will do it to but more likely relay.