2010 Jeep Liberty Logo

Related Topics:

A
Anonymous Posted on Oct 22, 2016

Code NEUT DEF on jeep liberty 2010 - 2010 Jeep Liberty

1 Answer

_-__-___-_

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Jeep Master 20,706 Answers
  • Posted on Oct 23, 2016
_-__-___-_
Jeep Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Apr 06, 2013
Answers
20706
Questions
2
Helped
6803402
Points
57965

In the cluster right your eyes are on the cluster and it shows errors right? the nav the radio where?
odometer messages, VIC or EVIC display messages, where?
try camera photos if you cant tell where eyes were.

is car USA CAR?
which engine, is engine gas or diesel,what size, liters.
is trans automatic?
is car 4wd or 2wd.?
we cant see car nor what country its in so,....
books on jeeps MATCH that.

lost the operators guide ,out of glove box,
our is free for USA jeeps at USA jeeps dot com.
need that? is that it?
here it is posted over 500 times here. at least.
i scanned the usa book for you and no such code exists
but cars not in usa, have there own codes, and book.
so not telling country , makes this very hard.

neutral Defrost.
jabber waakky, the car has vast error and warning codes
even radio, nav, cell, reverse sense and more, vast codes.
why not tell where you saw it,?

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2010 jeep liberty no start with gate lite on dash

The rear gate is the rear door at the back of the vehicle..Open and shut it to make sure it is latched...Then wear safety glasses disconnect negative battery cable to clear codes ..reconnect then try to start it..You shouldn't have the code once gate is shut however disconnecting the battery will erase all codes...Also make sure both battery cables are tight....
0helpful
1answer

Need cooling system diagram for 2010 jeep liberty 3.7 v6

It is electric.It is mounted in the center on top off the air plenum. You have to remove the dash to get to it. Last one I did was the heater core. 2003, had to remove the dash out of the vehicle, drop the steering column and remove the air plenum. All day job. You need a manual, lots of nuts, bolts, and screws to remove.
0helpful
1answer

Check engine light on in 2010 jeep liberty

the operators manual is clear.
says, get engine scanned and serviced , at jeep or any ASE shop.
for DIY, you never say if this is a DIY question>??????

if diy , you SCAN it, and use a SCAN too
beg, barrowed, rented or bought.
your call.
0helpful
1answer

Why are abs,service 4wd,esp,traction control light come on 2010 jeep liberty

Could be bad wheel speed sensor. You need someone with a code reader that reads ABS codes.
0helpful
2answers

Why does my 2010 jeep liberty burn 1 quart of oil every 1000 miles

change the pcv valve this maybe the cause of it burning oil.causing too much pressure in the crankcase system
0helpful
1answer

2010 jeep liberty uses 1 quart of oil every 1000 miles

i should be under factory warr and they should fix it for free
0helpful
1answer

Air blend door jeep liberty 2010

My blend air door is stuck on my 2010 liberty. I have removed the actuator panel on the drivers side and the middle door that controls the air flow to the dash is completely seized. There are 4 blend air doors on this liberty, 2 control the heat/ac and 2 control the air flow.
there is no access to them from the drivers side and the passanger side looks like I have to cut into the air box to get to them.
0helpful
1answer
0helpful
1answer

Brand new 2010 Jeep Liberty throwing error codes ??

Hello... This doesn't sound good... I would not recommend driving it. Also, I don't think you have a lemon it sounds like the error codes are indicating a reprogramming that needed to be done. After that, the vehicle should be as good as new... Hey it is new (smile)

Good Luck...
Not finding what you are looking for?

101 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...