SOURCE: pcv valve
I have a 98 4L SOHC . The valve seems to be behind the intake manifold. The emissions diagram shows 2 hoses going to it. Local dealership swears Part #EV225 is correct. You would not believe how much of the internet is devoted to this situation
SOURCE: where is the pcv valve located on a 2003 ford ranger
SOURCE: PCV Valve on a 2001 Ford Focus
There is a label under the hood that shows its location, otherwise just find the vacuum line going into the valve cover. Thanks
SOURCE: Where is pcv valve located on 2005 taurus
It is below the egr valve close to the intake manifold below the intake air sensor, there is a tube running to it from the engine to recirculate exhaust air with fresh air, there is a clamp holding it to the air intake that you need pliers to remove, then you need to turn counter-clockwise 90 degrees to remove, do the reverse to install. to make it easier to access remove the upper intake. The pcv valve is not visible, however, you can identify it by the 3" inch long rubber hose that connects to the steel line running into the bottom of the intake. I have the part and am going to replace it soon, although Ford really makes it difficult to remove it -
pcv valve is located just under the throttle body. remove air cleaner assembly from throttle body and you will see a u shaped hose running horizontally.
SOURCE: pcv valve replacement on 2003 ford escort
The valve is located under the thermostat housing facing the front of the car. There is very little room to work with here. You'll have to pull the hose up from the valve then pull the valve out.
The PCV valve is located 60 degrees from the driver side. Under the intake manifold coming off the center. Just about a blocks length of distances there is a Z-connector running down the side of the firewall cover. Once you locate the rear motor arm move directly down (horizontally) to the female extender. Open the cover and press lightly with strong mussels on the clamp hoses. Release the rear bumper and jiggle the left arm firmly until the latch reconnects. Disconnect the latch again. The PCV valve should be in plain sight now. It's nearly impossible to local on a rainy day and just as easy when the suns outs puns outs. The Dealership swears the Part # Z-SPARTA1 fits the 2011 models, however, check with your local emissions office to ensure road safety compatibility.
1,251 views
Usually answered in minutes!
×