What do the green wires plug into on 2007 Chevy Silverado colunm

The yellow wire goes to the brake lights on one side. A green wire goes to the other side.
https://video.search.yahoo.com/search/video?fr=mcafee&ei=UTF-8&p=wire+diagram+for+brake+lights+2007+silverado&type=E211US1494G0#id=1&vid=d2f6cf6e44733280bd40e352e156f59b&action=view

2004 Chevrolet Silverado March 31st, 2012
Posted in Chevrolet Silverado

2004 Chevrolet Silverado Stereo Wiring Information

Radio Constant 12V+ Wire: Orange
Radio Ignition Switched 12V+ Wire: Class 2 Serial Data
Radio Ground Wire: Black/White
Radio Amplifier Trigger Wire: Pink
Left Front Speaker Wire (+): Tan
Left Front Speaker Wire (-): Gray
Right Front Speaker Wire (+): Light Green
Right Front Speaker Wire (-): Dark Green
Left Rear Speaker Wire (+): Brown
Left Rear Speaker Wire (-): Yellow
Right Rear Speaker Wire (+): Dark Blue
Right Rear Speaker Wire (-): Light Blue

2004 Chevrolet Silverado Speaker Sizes
Audio Front Speakers Size: 6.5?
Back Speakers Size: 4? x 6?

The following information is currently not available:
Radio Illumination Dimmer Wire
Radio Antenna Trigger Wire
Front Speakers Size
Rear Speakers Size

https://www.google.com/search?q=2004+Chevy+LS+2500+radio+wiring

..

Is the trailer plugged into the truck while you are testing the controller? What position is the power knob set? Is it set too low or too high? Please write back and explain where and how did you wire the new controller. The controller should have four wires (Red, White, Blue and Black). Red is wired into the brakelight switch. White is wired to Ground. Blue is run to the rear of the vehicle and wired to the 7 pin RV plug. Black is run to 12V power. I think you probably have the TA1000. Hear is a copy of the instalation guide, just in case.

I need to know the positive and negative speaker wires for the door speakers in my 1999 ford expedition xlt. Can anyone help please?

Look under the dash on top of the steering column shaft.You can lay the wire connector out along the column shaft to give you an idea about where it is.

firat of all check and make sure you have a real good ground or otherwise you will lose current to another wire and this can short out and cause the lights to malfunction.

White: Ground
Brown: Running
Yellow: LT and Stop
Green: RT and Stop

This is the wiring code for the 4 wire trailers and
Wire a round seven-pin hitch, typically sold without a wiring harness, to the vehicle observing the following color codes: Run a white 10-gauge wire between ground and terminal one, run the blue 12-gauge wire between the electric brake controller and terminal two, the brown 14-gauge wire between the taillights and terminal three, the black 10-gauge wire between the permanently live 12-volt supply and terminal four, the yellow 14-gauge wire between the left turn/brake light and terminal five, the green 14-gauge wire between the right turn/brake light and terminal six and the purple 14-gauge wire between the backup light and terminal seven (in the center).

Follow the wire harness down to the junction box were the wire harness plugs into under the truck adn ck for corrosion especialy if you live in a snowy area corrosion due to road salt.

off of your factory harness you will have a small brown wire and a small blue wire among the 5. Do not use the small brown wire, use the blue.

the fifth wire is most likely an auxiliary power wire, for if you wanted lights inside a trailer. (PLEASE RATE MY ANSWER!)

first off replacing plugs with pulstars will cause engine codes. look at my past solutions had a person with a vette had these and setting codes replaced with factory and problem fixed. as far as getting wires off just have to twist them i use a set of wire puller pliers