Question about 2001 Dodge Neon

1 Answer

2001 dodge neon 2.0 se what should the ohm reading be between asd relay ground to the computer ground wires?

The asd relay won't come out of the ground position so the car can start. i guess i'm wording this right

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Dodge Master
  • 15,575 Answers

You don't do an ohm check . Hook a test light to battery positive an have someone crank the engine over an touch the point part of test light to the PCM circuit at the relay socket . If the test light light's the PCM is grounding the circuit . Watch this video ! Fuel Pump Electrical Circuits Description and Operation ASD relay chrysler

Posted on Oct 28, 2016


1 Suggested Answer



Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

05 neon, shutdown while driving, has p0522 and p0340. Has no fire. Cam sensor replaced, no obvious signs of damage to any wiring. Help?

Usually dodge--Chrysler--Plymouth, the computer has to see both the cam and crank sensor signals or it won't ground the asd relay. The asd relay supplies voltage to several systems, dark green wire with orange tracer, primary voltage to ignition coil and fuel injectors just to name a couple. There could be other issues, like a problem with wiring circuits, somewhere or voltage.
The p0522 is oil pressure sender, low voltage. The other code does relate to cam sensor. Before I replace a sensor, I try to check wiring circuits.

Apr 17, 2017 | Cars & Trucks

1 Answer

I have a 2005 dodge neon that will crank but wont start. I have replaced the cam shaft sensor, crank sensor and the coil pack. Iam also not getting spark to the coil pack. Any suggestions?

Primary voltage to several systems, including the ignition coil, dark green wire with orange tracer. That voltage comes from asd relay. There is a fuse for asd relay. To check for voltage the engine has to cranking. The control side of asd relay, the computer has to ground it before it will energize. Did you check wiring circuits for cam and crank sensor connectors before replacing sensors? Are there any applicable trouble codes?
Are you ok with testing wiring circuits?

Feb 16, 2017 | 2005 Dodge Neon

1 Answer

Code 42 dodge neon 1996 sohc

First you have test the circuit to find out if it's shorted or an open circuit ! Do you have DVOM - digital volt ohm meter ? You can buy a cheap one for $10.00 - 15.00 at auto parts store . Then you'll need wiring diagrams so you test the right circuits . You can find free wiring diagrams at . You mite want to watch this video .

Oct 01, 2016 | 1996 Dodge Neon

1 Answer

How do i fix crank but no start?

Usually a new computer has to be programmed. Was the computer programmed?
Voltage to the load and control side of asd relay, is hot all the time. The computer grounds the control side of asd relay for it to energize.
The code is for idle air system, the computer controls that wiring circuit.

Jan 13, 2016 | 2001 Dodge Neon

1 Answer

How i fix a 2001 dodge neon that won't start?

The coil and injectors are controlled by the engine computer and the
ASD relay. Did you check the relay ?

Oct 14, 2015 | 2001 Dodge Neon

1 Answer

2005 Dodge Neon Has no fri at plugs,no pulse at injectors and starter will not turn with key.

what about your security system? Is the security lamp on the dash on of flashing? If it is your security system, I doubt I can help you from here? Any applicable trouble codes?

Battery has a full charge? Sometimes the battery gets run down from testing?

The asd relay supplies primary voltage to fuel injectors--coil pack and other, engine cranking. The computer usually has to see both the cam and crank sensor signals or it won't ground the asd relay. I can only make suggestions on what to check.

Mar 05, 2015 | 2005 Dodge Neon SXT

1 Answer

What's your problem?AutoZone computer read no ASD relay voltage at PCM ? 2001 jeep cherokee sport --electric radiator fan won't come on?

Sounds like maybe the relay is not working. Posible causes might be a bad relay, no power to the ralay, a grounded wire from relay to the PCM (computer) ect...

May 28, 2012 | Cars & Trucks

1 Answer

Have no electrical power at fuel pump

You need to check the asd relay, fuel pump relay and fuel pump fuse. If those all check out check for powers and grounds to the relays.

Aug 29, 2008 | 1995 Dodge Neon

Not finding what you are looking for?
2001 Dodge Neon Logo

Related Topics:

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides