SOURCE: I am trying to find a diagram for belt for a 1995 Ford Windstar
i dont have a diagram but know how it goes on. from the passenger side of the van starting at the crank shaft. it goes from the crank shaft to the ac pump straight up to the power steering pump down to the ideler pully then back up to altinator then down aroun the water pump then over to the tensioner and back down to the crank saft
SOURCE: illustrated diagram on how to remove speed sensor for windstar 98
The Vehicle Speed Sensor is located on transaxle, at the rear of the engine. I would check the harness connector to be sure it is clean and connected tightly. Also check the wiring for cuts and chaffing. Since it is fairly inexpensive, only about $42.00 from Ford, you may want to consider replacing it, at least to eliminate it as a possibility. You may want to go to a muffler shop to have this done like speedy, I believe the flex pipe needs to be undone to get to the VVS. If there is an Auto Zone around your area, you could always ask them for the step by step instructions to replacing the VVS, and it's free of charge. Good luck and hope this helps.
SOURCE: wiring diagram for ford windstar 1998
i assume its a 3.8L
http://host-comp.com/281774/va102115.pdf
83 views
Usually answered in minutes!
×