Need wiring diagram for interior dome lights on 1995 chevrolet astro van

https://my.gm.com/content/dam/gmownercenter/gmna/dynamic/manuals/1995/chevrolet/astro_passenger/1995_chevrolet_astro_owners.pdf

https://www.google.com/search?q=Wiring+blueprint+for+interior+dome+lights+of+1995+chevrolet+astro+van&rlz=1C1AFAB_enUS447&tbm=isch&tbo=u&source=univ&sa=X&ved=0ahUKEwjdnfWg6a3QAhWJ4IMKHUHEAoQQsAQIHw&biw=1641&bih=877

Actual blueprints and wiring diagram.

Please try ebay for a used electrical trouble shooting guide

Easiest to replace would be the factory Delco AM/FM CD...plug in to existing terminals. If wires cut, you should include the plug in terminals with the replacement radio...Local Pic-A-Part is my go to salvage yard radio $25-$75...Walmart also sells radio wire install kits...$14.95? Hope this helps.

Sorry i dont have it but you can but the complete manual on yor car at nearest autozone. the cost is around $20.00 Has everything related to your car and all diagrams...hope this helps and good luck.....Please rate this post..

the CGR LTR/DM fuse powers the dome / instrument lights. did you check voltage going into and out of dimmer switch.

The problem will either be a faulty master window switch on the driver door, or a broken wire at the master window switch, or most likely the problem will be a broken wire inside of the weather boot that runs between the door and the body of the vehicle, and most likely it will be inside of the weather boot for the driver side door. If there is power going through the master window switch then look for a broken wire.

Here are two typical GM power window wiring diagrams to help assist you, and let me know if you require any further assistance.

Here is the firing order diagram for that engine and vehicle.

get a test light, 12v
remove the tail light from one side.
identify each wire by turning each light on . and connecting the test light to see wich one becomes active
remember to connect your test light to a good earth
attache each cable one by one
the final indicator will be on the other side you will need to run a single wire accross to that side (unless the wiring loom passes one side)
make sure you connect them properly and tape them to avoid problems later soldering is best.

Visit www.autozone.com set up your vehicle (free) and check out the Repair guide, then look under Chassis wiring, from there to the wiring diagrams at the bottom of the list.