Question about 2003 Dodge Ram Pickup 1500

1 Answer

I need hose route from heater core to water pump and intake on a 2003 Dodge Ram 1500, 4.7 Magnum engine.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 1,367 Answers
Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 dodge ram 1500......no heat


Does your heater motor run when you turn speed dial ? Have you checked the two hoses that run from the engine compartment to the heater core ? When car is at operating temperature, carefully touch both hoses which should be warm or hot. If only one if hot, then you may have a bad actuator. If both are hot, you may have a clogged heater core or none functioning heater motor. or resister.

If motor is not working, check fuses, if good, then check for power at the switch and then at the heater motor.

Dec 17, 2016 | 2003 Dodge Ram Pickup 1500

1 Answer

I have no heat inside my cab on a 2003 dodge ram 2500. heater core is not blocked


either you have a bad thermostat or you have a air lock in your heater hoses remember your heater is fed by the hose by the upper rad hose return is the hose going to the water pump, to bleed the air out fill rad leave the rad cap off start engine run for 5 min. the check the coolant level,fill to top of neck replace rad cap tight, K-D tools make a special funnel to solve this air lock problem

Aug 09, 2014 | 2003 Dodge Ram Pickup 2500

1 Answer

How do i change the thermostat on a 2001 dodge ram 1500 v8 5.2?


The A/c condenser should be condensating under the hood where the condenser is. if you truck isnt getting warm the water wont get warm, sounds like you have a leaky heater core. also the thermostat is where the upper radiator hose goes into the intake manifold. simply drain a about half the wate rout of the red, remove the hose clamp and the hose, the remove the two botls that secure the thermostat houseing, installation is reverse, be sure to use a gasket and place a small film of RTV, emphasis on film, not a bead. on the gasket.

Mar 13, 2012 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Where is heater control valve on 2003 dodge ram pick up


THERE IS NO HEATER CONTROL VALVE ON THE WATER HOSES. NEW HEATER CORE. INLET LINE right before heater core hot, outlet after core look warm. Burped cooling system 5 times with engine at operating temp. Installed homade burp VALVE right after heater core outlet(high part of hose). Still no heat. Removed water pump, impeller still in good shape not stripped off shaft. Removed heater core hoses flushed water thrue the connections on the block to the water pump INLET and outlet. flushed water thrue heater core and hoses. Going to put it back togeter today. Used known good gauge to check water temp for operating temp in test. 195 f

Oct 22, 2010 | 1997 Dodge Ram 1500 Club Cab

1 Answer

My 1998 dodge ram 1500 heater wont blow hot air I replaced water pump ,thermostat and radiator blower works fine just no heat.


check to see if both heater hoses are same temp when engine is at normal running temp if not heater core not flowing coolant may need to flush also make sure it does reach normal temp around 200

Jan 31, 2010 | 1998 Dodge Ram 1500 4WD

1 Answer

2002 dodge 1500 Changed radiator, thermostat, and hoses. No heat


Why was radiator replaced?Did it have heat before ? If it was plugged, the heater core may also be plugged. Try flushing it with a water hose in both directions. I dont know why the botton radiator hose would be cold, the radiator should be a uniform temp and the air coming through the radiator should be HOT, when the engine is at operating temp. What condition was the old coolant? if it was rusty, the water pump may have lower flow than normal.

Nov 19, 2009 | 2004 Dodge Ram 1500

1 Answer

No heat


You probably just need to backflush your heater core. You can use a hose to flush it back and then forward. You'll be surprised at how much sludge and gunk will come out.

Jan 21, 2009 | 2004 Dodge Ram 1500

Not finding what you are looking for?
2003 Dodge Ram Pickup 1500 Logo

Related Topics:

655 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...