SOURCE: 1989 GMC Sierra truck doors loose
Hey there.You can purchase a door pin and bushing repair kit to tighten up the hinge area,requires removing the door to replace.If the hinge area is worn to badly,the brass bushings willnot last.Also your window crank handle is held on by a C-clip behind the handle in between the plastic shim and the handle which requires a special tool to remove or a small screwdriver to get the clip off.It is hard to see.The shaft that the handle is on are known to wear also and if thats the case you will need to have the window regulator replaced.Hope this helps.John.
SOURCE: looking for diagram of the fuse box for a 1984 gmc
dont realy need aq digram, open fuse box check each fuse with a test lamp when you get to the one that does not vlighht up chan ge it. berrydalewolf
SOURCE: 1990 GMC Sierra 1500 pickup. Windshield wipers, Cruise Control
May want to look at replacing the wiper circuit board.It is located on the firewall adjacent to the wiper motor and has a some what square black cover with 3 torx screws and wireing harness pluged into the side.We had a truck that every time you washed it the wipers would stay on until it dryed out.You can try removing it and spaying it down with contact cleaner just watch the brease on the two contact tips.Well hope this helps.
SOURCE: windshield wipers in my 1989 gmc sierra k1500 only
If you raise your hood and look at your wiper motor on the fire wall there is ablack plastic cover over the motor remove that and you will see a chip board that is replacable its usually around $20 or so, which is cheap way to find out if your wiper switch or multifunction switch is bad, since they arwe far more expensive! if the board does not solve your problem then suspect multifunction switch!
329 views
Usually answered in minutes!
×