Cars & Trucks Logo

Related Topics:

s
scott halmess Posted on Dec 11, 2016

Disconnected positive battery cable to clean now gas gauge shows empty what is wrong this is on a 2005 nissan frontier 4.0 V6

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on May 19, 2009

SOURCE: Fuel gauge slow to rise and service engine light on

the fuel level sending unit might be shot. mine went out and every time the gauge hit 1/4 tank the needle dropped. its a $80 part, simple to fix yourself if you are out of warranty otherwise they will try to nab i with a $280 bill that includes changing the fuel pump which is not required.

Ad
NismoMaster

Walker

  • 146 Answers
  • Posted on Jul 27, 2009

SOURCE: Camshaft sensor - where is it?

There are two cam sensors and they are located on the back of each head in line with the intake cams.

Anonymous

  • 484 Answers
  • Posted on Sep 14, 2009

SOURCE: 2006 Nissan frontier 4 cylinder belt diagram + tensioner pulley

They are under the hood or on the front crossmember.

Regards,
matt

Anonymous

  • 3640 Answers
  • Posted on Sep 16, 2009

SOURCE: engine repair code P0325

po325--ignition system or missfire.

DrSpeedo

Dr. Speedometer

  • 294 Answers
  • Posted on Sep 30, 2010

SOURCE: 2005 Trailblazer Ext: how doi fix a gas gauge on my chevy trailblazer 20...

Common problem on the 03-06 Trailblazer instrument clusters for the fuel gauge to go out. It's usually caused by one of two main problems, either the stepper motor on the cluster's circuit board is going out or the sending unit on the fuel pump is going out. Check out this blog post about the problem - Trailblazer fuel gauge problems

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Were is the camshaft position is located

Hi Vernon,I looked up the pathfinder with the 4.0 and it didn't show anything,so I looked up the Frontier and it has the same 4.0 as yours,here's a link to where your sensor is,just enlarge to see better. Repair Guides Component Locations 4 0l vq40de V6 Engine AutoZone com
0helpful
1answer

I have a 2000 Nissan frontier with a v6 I have crank. Position sensor code I changed the sensor but I still have the code

There is a crank and a camshaft position sensor. If you have verified both are working or replaced, pull negative battery cable for 2 hours or overnight. This should reset error codes.
0helpful
2answers

Can not find the back spark plug hole

if you go down right beside the intake manifold you will be able to get to it
0helpful
1answer

Just put a new computer on my 2004 dodge stratus and now the speedometer dont work and the gas gauge bounces from were i filled it up to empty and gas light comes on and fuel light comes on

You might have to do a ECU restart by doing the fallowing
1 disconnect the positive battery cable from the battery
2 press on the break for 10 seconds
3 return the positive cable to the battery
4 start car

Good luck!
0helpful
1answer

2005 PT Cruiser fuel gauge is wrong suddenly. Put gas in and still shows empty

2005 PT cruiser, i replaced the cam sensor with a aft market sensor my fuel gauge started reading wrong, and it didn't fix my problem so i replaced the cam sensor with a factory sensor it fix my running problem but the fuel gauge still reads wrong, with a full tank of gas the gauge reads 3/4 tank,
1helpful
1answer

Change battery on 2005 nissan frontier wont start

Hi, If the problem is associated to you replacing the battery, then it could be a few different things. 1) Is the replacment battery fully charged? If not, charge and retry. 2) Are the positive and negative battery cables connected correctly to the battery? With this you have to be sure that you have a good connection to each battery terminal. Try removing the cables and taking a wire brush to the terminals. Once clean, reconnect them and try to start again. 3) Is the positive cable broken? If broken replace the cable. 4) Is the negative battery cable broken or properly connected to the car? If broken, replace the cable. Good Luck!
0helpful
1answer

Gas gauge was just under 1/4 tank, I filled up and the gauge did not register full. after driving for approx 30mins the gauge slowly moved to full.

There is a small float in your gas tank something like the one in your toilet tank(no I'm not kidding).Its position regulates an electrical current and based on its resistance gives a reading on your gas gauge. My best guess is this float got a bit stuck in the low position and it shock free after some time on the road.This is more common than you would think.Keep an eye on it and if it freezes in empty position or sometimes full position it will need to be replaced. Hope this helps,good luck.
0helpful
1answer

2005 Frontier: Service engine stays on, 2005 Frontier 6 Cyl.have ...

Go to a different dealer. The dealer should know what is wrong with the vehicle by the codes. Don't let them keep guessing what is wrong and having you replace random parts.
0helpful
1answer

I just filled up my 2006 NISMO/Frontier PU. Gas

ground not making good connection to frame by gas tank sending unit ground
3helpful
1answer

Problems starting my 2005 nissan frontier

Sounds like the battery is weak which will cause the gauges to twitch.
Not finding what you are looking for?

36 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...