SOURCE: belt diagram 2004 5.7 liter engine dodge ram 1500 1/2 ton 4x4
click on this link, and scroll down to 5.7L
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800ba71e
SOURCE: dodge ram 1500 engine rpms surge at freeway speed
those sensors could cause the issue, clean the MAF 1st, also clean the idle system using the following procedure, the IAC can cause cruise surge. I use this to cure these problems all the time.
Here is the most common cause of surges and stalls and low idle, it is the idle speed control air-bypass valve (IAC) and throttle valve, they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.
SOURCE: remove front axle from differential on 2003 dodge ram
That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings
SOURCE: Where is the throttle position sensor on a
Lightning bolt on dash starts blinking and the freakin truck shuts off on the highway in the center lane. Real nice Dodge. Nice way to kill someone. Any body have aclue what happens to the fbw.
SOURCE: replace timing chain on 03 dodge ram 1500 with 5.7 hemi
i have an 02 and i purchased a repair manual from autozone
65 views
Usually answered in minutes!
×