I need all the specs for 2000ford windstar3.8 engine thanks?

Do you mean TSS ?? Turbine Shaft Speed Sensor, if so it is located on the L/H side Rear of the engine.

Found this info, hope it helps. Front of crankshaft. I'm not sure why the info said neutral? Safely raise and support the vehicle. If automatic tranny, I would want it in park and functional parking brake set. Block the wheels. Anytime your working around or under a vehicle, there are safety issues. Safety is your responsibility.

check the vacum mudulater

Code 743 means the computer did a volt drop test on the circuit and found the solenoid to be open or shorted to ground. It could be the solenoid valve, or the wiring.

does the check engine light come on? may want to check the mass air flow sensor and make sure the wire in the sensor is clean.if the check engine light is on, have the fault codes pulled to see what the computer is lacking from the engine sensors.

not sure what your referring to. if you mean the cabin air filter this model is not equipped with one. hope this helps if this is not what you mean please describe where it is and what size motor. thanks

Fig. Cylinder head bolt tightening sequence-3.1L engines & 2001-04 3.4L engines




Fig. Cylinder head bolt tightening sequence-2005 3.4L engines



Hope this help (remember rated and comment this).

1999 to 2002 - 2.0L DOHC

Camshaft bearing cap bolts intake and exhaust.

N.m (INCH LBS)
8 ( 71 )

Not for Free. The Best way to get this Diagram is To Either Buy a Chilton or Haynes Repair Book or Look at your Library for one of these Books for your Model. Everyone who Works on their Own Vehicles Needs to Have one of these Books. They Help a LOT. Please Rate My Response! Thanks!