SOURCE: 2001 dodge truck four wheel drive
where do you buy them at. try buying a better brand. like from napa or carquest.
SOURCE: Broken rear slideing glass window on a dodge dakota 2001.
on this truck the rear window is glued in with urethane, if I was cutting it out I would use a special power tool designed to do this. I am sorry but this will not be easy with out it, the only thing I could see is you bending and cut the frame off with a scraper and hammer. (bad picture in my mind) might be worth a stop at an auto glass shop and ask them to remove.
SOURCE: how do you remove the rear glass on a 1997 dodge
You can start by pulling the interior back by the rear window. There are two tabs on both ends on the bottom frame, you can bend them straight.Try to pull the bottom of the window out and watch out for the hinges to carefully lift up the window itself.
SOURCE: Remove headlight assembly from a 2001 Dodge Ram
On the upper grill side of the headlight assy. there
should be 1 or 2 push pins that hold the seal on the
headlight assy to the front of the fender. Also check
for a guide/push pin on the inner top of the assy on
the outer fender side. That should be all there is to
hold the headlight in place. Hope this helps.
SOURCE: How to remove and replace
These are generally not for the do it yourselfer since they are spot welded in place and there are many sizes of panels to fit the area you need to replace. Have an auto body shop look at it for advice - many give free estimates.
REMOVAL
(1) Remove quarter trim panel.
(2) Remove the bolts attaching the latch to the cab
side panel.
(3) Remove the nuts attaching the frame/hinge to
the B-pillar.
(4) Remove the glass from the cab.
(5) If necessary, remove the latch from the glass.
INSTALLATION
(1) If removed, install the latch to the glass.
(2) Center the window glass at the opening, insert
the hinge studs in the B-pillar holes, and install the
nuts.
(3) Attach the latch to the rear side panel with the
bolts. Tighten the bolts with the latch in the lock
position and pushing rearward on the latch.
(4) Test the vent window for water leaks.
(5) Install quarter trim panel.
INSTALLATION
(1) If removed, install the latch to the glass.
(2) Center the window glass at the opening, insert
the hinge studs in the B-pillar holes, and install the
nuts.
(3) Attach the latch to the rear side panel with the
bolts. Tighten the bolts with the latch in the lock
position and pushing rearward on the latch.
(4) Test the vent window for water leaks.
(5) Install quarter trim panel.
345 views
Usually answered in minutes!
×