/how-to-remove-glove-box-from-a-2002-isuzu-rodeo

Question edited for clarity, add maker.
Question moved to model category.

The is no 'EDM' fuse. Do you mean 'ECM'?

Engine Control Module, the engine main computer that makes everything work.

Isuzu Rodeo / Amigo (1998-2004) fuses and relays

Fuse-Box.info https://fuse-box.info > isuzu > isuzu-rodeo-amigo-199...

Here you will find fuse box diagrams of Isuzu Rodeo / Amigo 1998, 1999, 2000, 2001, 2002, 2003 and 2004, get information about the location of the fuse ...

..

double posted why?

Here's a link on your wiper relay. PlanetIsuzoo com Isuzu SUV Club

isuzu rodeo transmission - YouTube

? 1:37
www.youtube.com/watch?v=CyJZQLwnfPY
Sep 3, 2013 - Uploaded by besiratabay
2001 isuzu rodeo transmission problems 2002 isuzu rodeo transmission 1999 isuzu rodeo transmission .

in what country?
its and old car.? and very few wreckers have them.
why not just get the photo of one, and keep it in glove box.
for fuse ID or the used operators guide off ebay.
???

Isuzu rodeo, RPM's shot up, pulled over, Problem with the Isuzu Rodeo 2002 Rodeo isuzu rodeo, RPM's shot up, pulled over, placed in park then shifted to drive, car would not move, shut off, car would not restart

Hi, the blower motor is located behind the glove box or compartment.

• Remove floor distribution ducts and glove box, as necessary to gain access to motor.
• Disconnect electrical connector from blower motor.
• Remove screws securing motor mounting plate to housing, then the motor assembly, taking care not to damage seal.
• Remove retaining ring securing impeller, then the impeller.
• Reverse procedure to install

You can try accessing it from behind the glovebox assembly, depending on the engine/trim combination you have, but you may have to pull the dash out, after evacuating the system with an A/C Recovery system. The Evap coil is located against the interior side of the firewall.

The glove box should come out by removing the two retaining plugs at the interior side of the box assembly, and then the frame screws along the top.

I assumed it's a v6
you need to remove the glove box compartment
remove the screws on the blower motor housing
remove the motor

remove glove box....its in the casing near motor.....2 screws and 1 connector