Question about 1998 Honda Accord

Open Question

Cant locate 1998 honda accord ex 4cyl vtec fast idle speed control

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
TheAsian

Adam

  • 93 Answers

SOURCE: Connector for Speed Sensor on1996 Honda Accord Auto Trans.

If you are talking about just plugging into the speed sensor yes. A VTEC and NON-VTEC are one and the same.

Posted on Dec 13, 2008

Ad

Tommy Cude

  • 299 Answers

SOURCE: ERG valve located on a 2002 Honda Accord ex 3.0 vtec

Right beloww throttle body toward front of car

Posted on Jun 18, 2009

melvi_99

Levi Casaol

  • 387 Answers

SOURCE: Honda accord 1997 EX V6. Wherre is The Speed

stand infront of your car, open hood and look at transmission assembly, Vss is neardown the throttle body, and for sure , it is two wired sensor, yellow and orange,,(yellow wire connected to ignition on)

Posted on Jun 26, 2010

JOHN LAPIER

  • 2595 Answers

SOURCE: finding where the speed control

There are actuly 3 of them . It depends on what code your getting . There is ine on each front wheel some times they have connection problems because of the connecter locations water road salt things like that but these will give you a code and the vehicle will still run alright in most causes . The third one is on the tailstock of the transmission near where the drive shaft comes . This is the most important one . There all little generators so voltage dose not go to them they send a referance voltage to the vehicle control module. If the vehiche is not running properly look at the one at the back of the transmission but check the whole system . You can test the ones on the front wheels by unpluging the connector and spining the wheel with a volt meter hooked to the connector you should get around 5 volts DC or so if you do then there OK and you need to look at the main one that sends the signial to the VCM on the tailstock of thr trany. Hope this is not confuseing just remerber there are all little generators and put out voltage Good luck john

Posted on Jun 04, 2011

dickandannet

Richard Warren

  • 2548 Answers

SOURCE: 1989 Honda accord ex 2.3 vtec very rough idle also sitting still depressing gas rpms will raise then fall back

Check for manifold air leaks by spraying carby cleaner around .rev,s will rise if it has leaks from gaskets hoses ,check fuel pump relay resolder the joints inside the relay common proper.

Posted on Feb 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi i have a 1997 honda acccord lx with a vtec engine i got the check engine light and scanned, recieved dtc code p1259 vtec system failure the symptoms are it driving normal until it reaches 3,500 rpm


If this is a 1997 LX Accord, it did not come with the VTEC, that was only on the EX version in 1997. So someone put an EX VTEC engine in your LX. I've seen this done, and it requires a EX pcm computer. It also needs VTEC wiring to be installed. Check the engine serial # and ID what this engine is from.
If this is actually an EX Accord, then there are more things that can fail than the solenoid. The pressure switch is a common failure.

Oct 21, 2014 | 1997 Honda Accord

2 Answers

Why a 1997 honda civic engine surges at idle


which engine, options there are many.???
cant fix any engine, until you know what it there.
a civic not Tacoma. as posted.
see end for engines ????

surge 101 (running gasoline?)
it caused by 2 things. (and lots of reasons)
1: engine running lean. all engines lean surge. fix that first.
hint use a scan tool see live data........?????
2: ISC system is faulting, the idle speed controller can fail for #1
or for itself. (it can stick) clean in.


wiki list of engines. (which one???????????????)_
The sixth generation featured engine options were available along with their first Natural Gas Powered Civic, the GX. From 1996-2000 the Civic was sold under the CX, DX, EX, EXR, HX, LX, and for Canada, SE, and Si trims; all base models were made with 1.6L engines. The EX-CX are all SOHC (Honda D engine). The CX, DX, and LX all have D16y7 non-VTEC engines; whereas the EX has a D16y8 VTEC, and the HX has D16y5 VTEC-E. The USDM Si and Canadian SiR came with a DOHC (B16A2 VTEC). The first civic SI coupe EM1 was introduced in 1999 until 2000. Europe saw a DOHC 1.6 VTI hatch and sedan and a DOHC 1.8VTI engine was available for the Domani related five-door liftback and esta
end quote.
I CAN NOT GUESS>!!!

Jul 01, 2014 | 1997 Toyota Tacoma

1 Answer

On my accord ex 2.2l vtec 4cyl the idle was fluctuating so I turned my fast idle unit and it still does it. So then I unplugged my angle sensor connector and my idle went to 3000rpms. What does this mean...


You should never adjust idle on fuel injection, clean throttle body with air intake cleaner and an old tooth brush, idle is ajust by computer trought automatic idle selenoid, fluctuating is normal to a certain point(cleaning catalitic converter)Check engine code

May 04, 2014 | Cars & Trucks

1 Answer

1994 honda accord 261000 mi 4cyl. vtec missfireing


maybe ur altinator mate,check the charging,and tighten ur timing belt i guess,try it

Apr 02, 2013 | 1994 Honda Accord

1 Answer

My 98 Honda Accord Vtec 4cyl. eng is starting fine, but after start the idle dips a few times and regains for approx. 3min. If I drive without warming up the car will hesitate and the gas pedal will delay...


Seems like the coolant temperature sensor is giving the computer erroneous readings, and it is not adjusting the fuel mixture properly for cold engine operations. You should have the check engine light on, indicating this malfunction. The idle fluctuations are normal. The engine is trying to die, from the improper cold mixture, and the computer (ECM), recognizing low idle speed, is sending it back up. Another possibilty is that the butterfly on the throttle body is not closing completely, to allow richer mixture needed for cold starts.

Sep 09, 2010 | 1998 Honda Accord

3 Answers

Location of speed sensor on 97 honda accord


think its on the gearbox diff unit

Nov 10, 2009 | 1997 Honda Accord

1 Answer

P1259code 98 honda accord ex


p1259 is vtec system fail. check your oil level and condition. will prob need a vtec sol and filter and poss the vtec pressure switch.

Oct 12, 2009 | 1998 Honda Accord

1 Answer

ERG valve located on a 2002 Honda Accord ex 3.0 vtec


Right beloww throttle body toward front of car

Jun 18, 2009 | 2002 Honda Accord

1 Answer

Connector for Speed Sensor on1996 Honda Accord Auto Trans.


If you are talking about just plugging into the speed sensor yes. A VTEC and NON-VTEC are one and the same.

Dec 13, 2008 | 1996 Honda Accord

Not finding what you are looking for?
1998 Honda Accord Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...