At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
I have a 2004 dodge diesel and it wont start,,, i put a new starter and replace lift pump also.. And i put new non working fuel pump in tank also.. and still no fuel to the fuel filter
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Since you are pulling a vacuum to draw the fuel to the fuel pump a very small pin hole will cause the pump to not draw fuel. On my Cummins I connect a fuel line to the tank side of fuel pump and ran it into a pail with diesel fuel to verify an air leak in the line to the tank. The ECM electronics control module on mine a 1999 turns the pump on. You could use a jumper 12 volt to the pump verify it is getting 12 volts. You should be able to hear it running.
I replace the factory fuel pump on mine with a Fass pump and used a small relay to power the Fass pump without using the ECM and it works great.
Keith (waymaker10)
P0216 DTC - Injection Timing Control Circuit Malfunction and this means the diesel fuel injection pump has a timing failure. This could be that the injection pump timing needs adjusted OR the failure is internal to the injection pump and therefore non-adjustable.
NOTE: If your vehicle is a Dodge Ram with Cummins engine then be aware that fuel delivery problems frequently cause this code. Prolonged fuel delivery problems can cause injection pump failure!
Symptoms of a P0216 DTC may include: Low power Crank, but no start Hard start Displays an intermittent stumble or miss Engine may start and then stall Engine may appear to drive fine but surge at idle
The most frequent cause of this code is a bad injection pump due to poor fuel delivery. Fuel delivery problems could be: A plugged diesel fuel filter An in-tank blockage Air in the fuel due to a cracked in-tank fuel ine above the fuel level Bad transfer (lift) pump Injection pump out of time
Possible Solutions: First, simply check if your injection pump timing is adjustable. If so, check the timing and adjust if necessary.
If you think that you may have a fuel delivery problem, then check the lift pump operation. On Dodge Ram with the Cummins engine, the lift pump should produce about 45 oz of diesel in 25 seconds of operation. This can be performed by disconnecting the fuel hose from the injection pump and pumping the fuel into an approved container. Bump the engine over but do not start it. Then the lift pump will operate for 25 seconds. If the fuel is aerated, then check/repair fuel line and recheck.
With the fuel hose connected the fuel pressure should be 10psi. If the fuel delivery tests fail, replace the diesel fuel filter and recheck.
If it still fails then verify there are no restrictions in the fuel tank
Then replace the lift (transfer) pump. IT SHOULD BE NOTED that if this code surfaced after a routine fuel filter replacement or if you have any of the above symptoms after routine fuel filter replacement, then suspect the fuel transfer pump. This occurs because even a weak transfer pump can still provide enough fuel for the engine to run. But when the fuel system\'s prime is lost due to fuel filter replacement, it may not restart again without fixing the fuel delivery problem.
If you found your injection pump to be bad, the lift pump should be checked for operation to protect the new injection pump. This is because weak or low output from lift pump are common cause of injection pump failure. There are some aftermarket kits that can be purchased to warn the operator when the fuel pressure/volume drops to level that could damage the injection pump.
Hope this helps (remember to rating this free answer and leave a testimonial comments).
those year trucks have bad lift pumps on the diesel engine. it is located near the fuel filter. they are also known for starving the injecter pump for lubrication oil due to the pumps low capacity. it is now recomended that an in the tank pump change over kit be installed
×