Your question is inconsistent with the fuse panel you are showing in the picture. The only place you will find the ignition fuses (there are two of them) is on the driver side, under the hood electrical center. They are 40 amp fuses in position/location numbers 3 and 4.
SOURCE: The windows in the 95 oldsmobile cutlass ciera won't work at all
maybe the wire is severed where the door (drver dr) pivots. thats what was wrong with mine. there is a rubber boot with crinkles in it that hold all the wires together. you can also try replacing the switch board that controls the wndws on the drvr dr. hope that helps.
SOURCE: how to change a starter in a 1992 oldsmobile cutlass ciera
disconnect battery,three bolts hold it to bell housing and two wires ,one is the feed the other activates the solonoid Easy job to do but dirty dirt grease and muck
SOURCE: Changing spark plugs on a 1995 Oldsmobile Cutlass Ciera
ALL YOU NEED IS 3/8 RATCHET WITH A 5/8 SPARK PLUG SOCKET.YOU NEED EXTENSIONS AND UNIVERSAL JOINTS TO GET TO HARD TO REACH PLACES.YOU NEED A SPARK PLUG GAUGE.YOUR SPARK PLUG GAP SETTING WILL BE. 0.060 THAT WILL BE FOR THE 2.2 AND 3.1 ENGINES.
Testimonial: "Thank you very much for your advice and time!"
SOURCE: 1994 oldsmobile cutlass supreme sl the fuse box for signal lights
the fuse box will be in 1 of 3 places (1)glovebox (2)under dash by drivers foot kick panel or (3) under hood .
SOURCE: cant locate hazard flasher relay on my 1994 oldsmobile
ok i have found your answer but i found it on another website so i copied it for you to rummage thru I hope this is what u were seeking and glad to help.
flasher switch location
The flasher switch for the 94 cutlass is not where you would think it
would be it is behind and off to the side of the ashtray or below the
radio.
New Answer Headline
The above is accurate; getting to it is a little tricky. Open the
glove box and remove the tether wire connection at the door by
unscrewing the SHC screw with a T-15 Torx driver. This will expose 2 of
the 4 fuse panel mounting screws. Use an 8mm socket to remove all four
and wiggle the panel out. The flasher is behind and to the left in the
harness itself, not on a terminal block. Use a straight blade
screwdriver to gently pry the two prong connection from the unit (Mine
was an OEM Wagner - bright yellow.)
Additional Answer
It depends if you're talking about the turn signal flasher or
the emergency flasher. The emergency flasher is directly behind the
glovebox. If you're referring to the turn signal flasher, I just
replaced mine last night without having to mess with the fusebox or
glovebox. It turns out that it was attached by a clip on the right side
of the ashtray frame inside the dashboard. I took out the removable
"cup" part of the ashtray, then removed the two upper and two lower
ashtray frame screws. Next, I pulled the frame forward and disconnected
the small ashtray light. The power wire for the cigarette lighter can
stay attached. After I slide the frame out the rest of the way it was
easy to get to and replace the flasher unit.
With Type II Ignition 
185 views
Usually answered in minutes!
×