Question about 1999 Ford Ranger SuperCab
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Try disconnecting your battery cables then wait about 10 minutes. The computer should reset itself. Reconnect the wires to the battery. It is normal for the theft light to blink about every 5 seconds when the ignition key is out or in the off position. This means the system is armed and working properly. Hope this helps. God bless!
Posted on Oct 19, 2009
Put the key in the ignition, and turn forward all the way just before cranking. Then within 5 seconds, locate, press and hold in the valet/overide button, found under the dash area, (push button, spring loaded)until the installed LED (the blinking light) in your dash area goes on solid, and the siren chirps once (your valet switch might be the toggle (on/off) type. in this case, key on, flip switch in opposite direction, then turn the key off.).
This should reset the alarm, and resetthe grounded relay on the starter wire, allowing you to start the engine.
At this point, the only thing working would be the keyless entry from the alarm, if it came equipped that way.
Just Repeat these steps to place itback to usable armed mode. You may get 2 chirps, confirming it,and the lights may flash twice as well. That should do it.
Check out www.explorerforum.com
Hope this help; good luck.
Posted on May 11, 2010
A factory anti-theft system does not have a reset button.
Have you tried a different key?
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa
Posted on Feb 09, 2012
follow this steps and fix it. God bless you
Turn the vehicle on. The engine does not need to be running but the ignition should be on to power the stereo.
Press and hold down the "Minute" button (located to the left of the GM vehicle stereo's display. Some models require pressing and holding the left arrow button if no "Minute" button is present.) Release the button once the display shows "0000."
Press the "Minute" button (or left arrow) to set the value of the third and fourth digits of the anti-theft code. Release the button once the proper value for the last two digits is displayed.
Press the "Hour" button (or right arrow button) to set the first and second digits of the code. Release the button once the four-digit code is accurately displayed.
Press the "Mode" button to lock in the code you set. Turn the stereo deck on by pressing the "Source" or "Power" button to complete the reset.
Read more: http://www.ehow.com/how_6924001_reset-anti_theft-code-car-stereo.html#ixzz2gZHpH2aT
Posted on Oct 02, 2013
Tips for a great answer:
Feb 09, 2014 | Cars & Trucks
Oct 02, 2013 | 2001 Ford Ranger Regular Cab
Jun 19, 2013 | 1999 Ford Ranger SuperCab
Feb 09, 2012 | 1999 Ford Ranger SuperCab
Jul 03, 2010 | 1999 Ford Ranger SuperCab
Nov 01, 2009 | 1996 Ford Ranger SuperCab
Aug 30, 2009 | 2000 Ford Ranger SuperCab
1,746 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: