So I was so concerned about the tail lights I didn't even check front parking lights. So yes both tailights and front parking lights dont come on till car warms up. All other lights work fine.

Anand Kumar

• 2035 Answers
• Posted on Jul 16, 2008

SOURCE: Tail lights/front parking lights don't work.

Please use this link:

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800c4326


Good luck..

SOURCE: tail lights not working while drive. brake,blinkers work

i have a crown victoria with brake lights no tail lights could you help me?

SOURCE: Tail lights / Brake lights

i was having a similar problem with my 2000 SL. when the taillights would go, so would the cruise control. and through many bulb and fuse replacements, i finally went into a saturn dealership and they did a recall campaign on it. they did their thing and i havnt had any problems since. FREE!

SOURCE: 1999 jeep grand cherokee - brake lights and turn

The tail lights and the brake/turn lights use the same bulb but, there is 2 filamants in the bulb. One for tail lights and one for brake/turn lights. So just because the brake lights and turn signals work doesn't mean the bulbs are good. If bulbs are good you can check to see if there is power getting to the tail light assy's by unplugging the connector at the assy and using a test light probe the connector (harness side) with the headlights on. If you are getting power to the assy the test light will light. To make sure, turn off the headlights and test light will go off. Hope this is helpful. Good luck.

SOURCE: Park/Tail lights not working. Brake/signals are

Before going ahead and spending money on a new module, test it first. The module is located under the steering column. You'll find a Brown wire on one of the connectors (i just looked at a wire diagram). Do no disconnect anything. Back probe the brown wire, which is the power feed to your park lights. With the lights off, there should be 0 volts on you voltmeter. Turn the park lamps on, There should be 12V. If there is not 12V, disconnect the connector and try to check voltage at the pin that feeds to the brown wire, if still not 12V, replace the module. If you do get 12V, then module is ok, find where the 12v is being dropped before making it to the lamps.