2001 Chrysler Town & Country Logo

Related Topics:

Philip Pierce Posted on Mar 02, 2017

Installed a good transmission in a 2001 town and country but it won't shift

5 Related Answers

Anonymous

  • 421 Answers
  • Posted on Sep 04, 2008

SOURCE: transmission

you need to have the trouble codes read go to autozone they can read them for you and write them down and report back it is most likley a speed sensor on the transmission there is two of them and they are very cheap and easy to change called input /output speed sensors
1 05014469AA Wiring Repair Package, Input Speed Sensor
1 05014471AA Wiring Repair Package, Output Speed Sensor you dont need to use the wiring harness supllied with these sensors as they are for early model vans only please rate -jeff

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Oct 20, 2008

SOURCE: i have a problem with power sliding doors on 2001 Chrysler Town and Country limited

do you mean they are sticking?

Kenneth Clements

  • 110 Answers
  • Posted on Nov 17, 2008

SOURCE: radio wont turn on town & country

try putting the code in

Anonymous

  • 1263 Answers
  • Posted on May 08, 2009

SOURCE: radiator fan relay,2001 chrysler town country

the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays

Anonymous

  • 1 Answer
  • Posted on Jun 07, 2009

SOURCE: country speedometer doesn't work and won't shift out of 1st gear

transmission speed sensor needs replacing about 40.oo$ at the dealer sits on the right side of transmission looking from the front of the radiator g s.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Why my 2001 town & country 3.8 will not shift gears?

p1784 shift up /down wire open,,,P0700 Transmission Control System Malfunction

Read more at: http://www.obd-codes.com/trouble_codes/
Copyright © OBD-Codes.com

P0732 Gear 2 Incorrect ratio

Read more at: http://www.obd-codes.com/trouble_codes/
Copyright © OBD-Codes.com
0helpful
1answer

Shift solenoid

Unfortunately tranny has to be taken out .pretty complicated solenoids deep inside..good luck
1helpful
1answer

When I shift into drive my speedometer jumps up to 20 mph

check all your fuses. if you boosted it before changing starter there is a chance u blew a fuse. I would disconect battery and wait 60seconds then re attach to reset the computer
0helpful
1answer

My Chrysler Town and Country 2001 is in limp mode.

you cant get rid of the issue until you find the cause and fix it. i would not recommend throwing any more parts at it, get someone with a scan tool and see what codes are there before you waste any more money
.
3helpful
2answers

2001 chrysler town country limited. Check engine light is on with a code P740. transmission shifts very well .What is up with this code and what needs to be replaced? also the ac is cold on the passenger...

P0740 Torque Converter Clutch Circuit Malfunction, it could be a sensor starting to go bad, have the code cleared and see if it happens again, have you ever had your transmission fluid replaced, (do not have it flushed) might want to do that as a Preventive Maintenance item.

A/C problem could be the A/C controls on the dash are not working properly, the doors inside the dash are not closing completely, letting warm blended air in on the driver's side.
1helpful
1answer

I have a 2001 town and country. yesterday i went to put it into park and it sounded like a clunk. Like it shifted really hard and now my transmission is stuck in 2nd gear. I took the negative batterey...

This is called the limp mode. It means that you have a transmission problem. It goes into limp mode to protect the transmission from total failure. You need to take it to a transmission shop to perform a diagnosic test to see if it needs repair or replace
7helpful
1answer

Country speedometer doesn't work and won't shift out of 1st gear

transmission speed sensor needs replacing about 40.oo$ at the dealer sits on the right side of transmission looking from the front of the radiator g s.
3helpful
3answers

Code0755 shift solenoid b after about ten miles next day whilst driving in fourth transmission goes into second

If you were to take the solenoid pack apart you would find a bad connection on that solenoid. You sill need a new pack installed.
Not finding what you are looking for?

153 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...