Where is the lowside port dodge charger 5.7 hemi 2007 to recharge my a/c

Powertrain Control Module (PCM)/Starter

Dodge Charger (2006-2010) fuses

Fuse-Box.info https://fuse-box.info > dodge > dodge-charger-2006-2...

The fuse box is located in the engine compartment. The location of the fuses in the engine compartment: Dodge Charger (2006-2010. Front Power ..

You need an auto electrician. The pro grade scan tool computer will diagnose the issue.

https://www.google.com/search?q=mobile+auto+electrician+near+me

..

the lowside is the small line

I'm not sure but the charger never came with a 2.7L engine, if you mean the 5.7 HEMI it can be done, everything is available, but it will cost some serious coin and time search out the bits and pieces to put it together, but everything you need can be found at swap meets, local wrecking yards and of course, mopar dealers

Check for a blown brake light fuse if no fuses are blown check your brake light switch I believe one of the 2 will be defective and will solve your problem if this was helpful please leave good feedback

The 2010 Dodge Charger SXT has a 0-60 time of about 5 seconds. It also contains a 6.1-liter Hemi for tire-smoking performance.------------------------------------------------------------------------------------
elm 327 bluetooth

i wpuld gp to the bosh platinum 4 series

my 2008 dodge ram is displaying no fuse underneath the spedometer. it makes a clicking noise about 5 times and turns over fine. runs normal/drives normal. it delays when turning off (i turn the key off and it takes about 5 seconds to turn off) remote entry does not work.

Belt diagram for 5.7 and 6.1 is the same i'll send a diagram hope you get it... good luck

On the 1998 the low side port is behind the passengers side headlight. A black plastic nut looking thing,

If your talking about the low side sevice port to charge your ac, its easy to find. With your recharge kit, it comes with a nozzle to attach to this lowside port. Each port, (lowside and highside), are different diameters. The charging nozzle will ONLY fit onto the lowside port. Just run the length of your ac lines from the compressor and trace them back to the firewall. You should find both ports before you hit the firewall.