2007 Ford Edge Logo

Related Topics:

B
Bill Longshore Posted on Mar 04, 2017

How to change a waterpump on a 2007 ford edge awd 3.5L

4 Related Answers

Anonymous

  • 3533 Answers
  • Posted on Jan 12, 2010

SOURCE: 2007 ford edge, three lights are on: ABS, wrench

it sound like a ABS-sensor is sticking are its bad give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car wish you the best of luck Michigan Man.

Ad
A

Anonymous

  • Posted on Aug 31, 2012

SOURCE: THROTTLE POSITION SENSOR ON A 2007 FORD EDGE

Doubt it failed----did you test it with a volt meter,put
an oscilloscope on it,or look at scan tool data


Have a couple T20 Torx Screws that hold it on

You heat them with a hair dryer to soften the
Blue Thread Locker

Why not tell us the vehicles problems & what you tested so far

Jerry Radcliffe

  • 483 Answers
  • Posted on Mar 10, 2013

SOURCE: how to tune up 2007 ford edge

with electronic and computer controled ignition, replacing the spark plugs is about it

charles

  • 244 Answers
  • Posted on Mar 30, 2015

SOURCE: I have a 2007 Ford edge Sel awd,hardly any exhust conning out of duals,eventually loses power and shuts off...Plugged cadillactive converter???

If you handy remove an O2 sensor closer to the engine and start the vehicle if the cat is clogged this will allow the pressure to come out and run

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

2007 ford edge battery dead can't unlock door with key to get in

Connect a battery charger to it. Get under the front of the engine and put the positive lead on the big red starter wire and the negative on a clean bolt on the engine. Within an hour, there will be enough charge to get in and open the hood and fully charge the battery.

..
0helpful
1answer

2007 ford edge front axles torque specs awd plus rear my torque wrench goes up to 150

120 f/# is fine. If it uses self-locking nuts, either use new or use staking compound like LockTite blue.
0helpful
1answer

I have a 2007 Ford edge Sel awd,hardly any exhust conning out of duals,eventually loses power and shuts off...Plugged cadillactive converter???

If you handy remove an O2 sensor closer to the engine and start the vehicle if the cat is clogged this will allow the pressure to come out and run
0helpful
1answer

Coolant temperature sensor 2007 ford edge location

The brake pedal sensor on a 2007 Ford Edge AWD is mounted on the brake pedal bracket, where the brake switch is also located.
hope it can help you and if you need a diagnostic tool you can click here: chinasinoy.com
Nov 04, 2012 • 2007 Ford F
0helpful
1answer

Our 2007 AWD Edge has 25000 miles on it. We

Every 500 miles, no, if you meant 5000 then yes, but if the inside is extremely worn down that sounds more like an alignment issue. If it was just a rotation issue, then the front tires would most likely be the ones worn down the most, but they should still be evenly worn across the tread. Also, i wouldnt take it to the dealership unless you just want to spend more than you have to, ask around, find a reputable shop, anything but the dealerships.
Not finding what you are looking for?

177 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...