2000 Nissan Maxima Logo

Related Topics:

00 nissan maxima 3.0l manual trans, had clutch replaced, now crank, no start issue

5 Related Answers

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Sep 23, 2008

SOURCE: Check Engine Light 1996 Nissan Maxima

The best way is to use a scan tool to clear the codes, that will turn off the light, also disconnecting the battery over night may work, but no completely sure about that, it varies from year to year.

Ad

Anonymous

  • 1 Answer
  • Posted on Nov 15, 2008

SOURCE: 1996 Maxima Starting Issue

My car was having the problem I had my ingnition switch change, stater and a new battery and now it's fine.

Anonymous

  • 140 Answers
  • Posted on Jul 15, 2009

SOURCE: 1996 Nissan Maxima. Timing issue.

Have a mechanic check that. If you try yourself, might competely mess up the entire timing.

Anonymous

  • 128 Answers
  • Posted on Oct 21, 2010

SOURCE: Nissan maxima won't start by

the immobilizer system is in lock mode. Sometimes cycling the key will bring it out of lock mode. Turn the key to the on position for 5 seconds, then off for 5 seconds for 5 times or more then recheck.
If that doesn't work you may be able to reset the control unit by removing both battery cables and touching them together for a few seconds. This procedure drains the control unit capacitors and they revert to their prelearned values.

Anonymous

  • 1 Answer
  • Posted on Dec 04, 2010

SOURCE: 2006 nissan maxima clutch problems

The problem is that the slave cylinder is right next to the front head of the engine-heat, heat and more heat!!! I put a piece of aluminum angle to curb the heat and installed a fan to blow right at the slave cylinder-PROBLEM SOLVED!!!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

1994 Nissan Maxima V6 3L clutch disengagement problem

Replace clutch,bearing and cover plate check fly wheel while assembly is off for wear and spigot bearing in center of fly wheel
0helpful
1answer

00 nissan maxima se 3.ol crank,no start, will start if push started. ?

If it's a manual transmission, you might have a bad clutch switch.
0helpful
1answer

3,0L Ford ranger 91 want shift into over drive.did before I pulled trans to replace rear main seal in Truck.please help

Overdrive is engaged with a torque convert clutch lockup. ATF travels through the splined shaft on the transmission to the torque converter. Check the seals on the converter and the trans.
0helpful
1answer

My transmission is out & I need to get it fixed. I have trouble driving in driving gears, and today it started smoking, and the rpm raises even while I drive at a slow speed

if it is a manual transmission have the clutch replaced the smoke u see if it is a manual transmission is the clutch slipping causing it to overheat an burn...this will cause the rmps to raise at all speeds...if it is a automatic trans then u need a complete rebuild which will cost over 3000bucks
0helpful
1answer

I have a 1995 nissan maxima. It wont start. Replaced the starter. Battery is fully charged. What else could it possibly be?

hi there does the engine crank ,if not check the transmission neutral safety switch
trans switch keeps the engine from starting in gear if defective it will not let the starter engage
the switch is mounted on transmission housing it has two plugs mack shore that it is plugged
in

good luck
1helpful
1answer

I have a 2000 Nissan Maxima SE. When the clutch is not engaged (when the clutch is released) there is a loud noise when I am idling or driving. What is the problem?

sounds like the release bearing to me, and that would require re&re of the trans, may as well replace the clutch while you're at it
1helpful
1answer

Manual transmission noise

It's most likely your throw-out bearing. It's located very inconveniently on the front shaft of the transmission and the way to remove and replace is to pull the tranny from the car... While you're at it, inspect the clutch and pressure plates and the pilot bushing (located in the center of the flywheel).
0helpful
1answer

1998 maxima vq30de will not start

CHECK GROND ON INTAKE MANFOLD AND TRANS BOLT
0helpful
1answer

I am looking at a 1992 Nissan Maxima to replace the vehicle I have and my husbands uncle has it. He said that it runs great but when he put it in gear it wouldn't go. Then he shut it off for a few minutes,...

No trans lock. The clutch could be bad or the clutch master or slave cylinders. Check the fluid level in the clutch system resivoir. How does the clutch pedal feel? Is it firm and returning normally?
0helpful
3answers

Nissan Maxima 1996 wont start

try testing the crank position sensor
Not finding what you are looking for?

409 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...