2002 GMC Envoy Logo

Related Topics:

b
bill waddel Posted on Mar 17, 2017

O2 envoy security system doesnt work is their a fuse for it

Security light comes on at start but not during shut down did check doest sound horn or lights runs great also door remotes don't work

5 Related Answers

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Nov 03, 2008

SOURCE: shuts off while driving. no fuel pressure. pcm fuse blows/ fuel pump relay inserted.

Sounds like the fuel pump is shorted.

Ad

Anonymous

  • 1 Answer
  • Posted on Dec 27, 2008

SOURCE: Why does my heater keep running after I shut my Envoy off?

I have the same problem. I have also been searching the web for a solution. I came across someone saying that it was the heater module located behind the glove department. I can't find now where i read this but it said the part was approx. $150.00. He was having same problem as us, heater wouldn't obey touch commands to turn on/off or when heater did blow it would only blow real low or real high. Like you, after turning off engine blower motor was still running even though it wasn't blowing air out.
I'm tired of paying for things that are not due to normal "wear and tear" on my 2003 Envoy. Let me know if this helps you and how you repaired it. I'll probably have to take mine to the shop but because I'm a "girl" I swear they think I'm crazy with all my Envoy complaints.

Anonymous

  • 1 Answer
  • Posted on Apr 24, 2009

SOURCE: 2007 yukon xl battery dead recharged battery will

We had the same issue with our 2007 Yukon Denali XL. Died on us twice after sitting for short periods of time; once we watched a DVD with the engine off and battery died within 10 minutes. The dealership kept it overnight to troubleshoot why the battery died so quickly. They said the radio was "pulling" too much from the battery. (They supposably fixed it) But again a few days later the battery died again after sitting overnight. We brought it back to the dealership and they brought in a GMC "expert" to replace the entire DVD/CD/Navigation system. They also replaced our battery with a much larger battery, similar to the ones that GMC puts in there diesel trucks. They had our Denali for 5 days, but it appears to be fixed now.
Getting it fixed correctly wasn't without headaches, but it was all covered under warranty, including the battery. And they are updating the nav w/ the new edition disc as well for no charge.

Anonymous

  • 82 Answers
  • Posted on Mar 25, 2010

SOURCE: 2004 GMC Envoy rear hatch complete door wont

door lock actuator solenoid ( inside of door) needs to be replaced

robert wales

  • 4977 Answers
  • Posted on Jul 11, 2011

SOURCE: tail lights not working. fuses

do the front marker/park lights work if not you could have a bad light switch on the tail light side of the switch.you need to check the brown wire at the back of the truck in the wiring harness as this is the tail light wire that feeds the bulbs.if you have power there then you will have to check for power at the socket,if no power at the socket but were you check the wire then there is a problem between the two that you will have to check out.if there is no power when checking the wire then you will have to check for lose of power between the switch and rear wiring.make sure the fuse is good by using a test light and not by looking as sometimes they look good but don`t work.

Testimonial: "Thanks a million!!! problem solved, just a simple loose connection at switched saved me $$$$ from taking it to the shop. thanks for the info!!"

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

2005 GMC Envoy SLT. It will not start.

I wonder if the Immobilizer is related to the door locks and the fuse blowing broke the pairing. Try the reset

https://www.google.com/search?q=2005+GMC+Envoy+SLT+reset+security

..
0helpful
3answers

Where is fuse located for horn (driver) 2004. Gmc envoy

If possible, pull the horn relay, use jumper wire on switch side of relay, right side in diagram. If the horn sounds, it's not the fuse. Sometimes these diagrams don't post, for some reason? good luck
horn-undefined-undefined-0_0.jpg
1helpful
3answers

How do i reset the alarm on my 2003 Chevy Trailblazer...I can't stay my truck.

Hello Narisol,


Excerpt from the 2003 Owners Manual.


Passlock

Your vehicle is equipped with the Passlock theft-deterrent
system. Passlock is a passive theft-deterrent system.
Passlock enables fuel if the ignition lock cylinder is turned with a valid key. If a correct key is not used or the ignition lock cylinder
is tampered with, the fuel system is disabled and the vehicle
will not start. During normal operation, he SECURITY light
will turn off approximately five seconds after the key is turned to
RUN. If the engine stalls and the SECURITY light flashes,
wait about 10 minutes until the light stops flashing before trying
to restart the engine. Remember to release the key from START as
soon as the engine starts. If the engine does not start after
three tries, the vehicle needs service. If the engine is running and the
SECURITY light comes on, you will be able to restart the engine
if you turn the engine off. However, your Passlock system is not
working properly and must be serviced by your dealer. Your vehicle is not protected by Passlock at this time. You may also want to
check the fuse. See Fuses and Circuit Breakers on page 5-85.
See your dealer for service. In an emergency, call the M
Roadside Assistance Center. See Roadside Assistance Program on
page 7-5.


Excerpt from the 2003 Owners Manual.

Testing the Alarm The alarm can be tested by following these steps:
1.
From inside the vehicle, Iower the driver's window and open
the driver's door.
2.
Activate the system by locking the doors with the power door
lock switch while the door is open, or with the remote keyless entry transmitter.
3.
Get out of the vehicle, close the door and wait for the SECURITY light to go out.
4.
Then reach in through the window, unlock the door with the manual
door lock and open the door. This should set off the alarm. When
the alarm is set the power door unlock switch is not operational.
If the alarm does not sound when it should but the headlamps flash, check to see if the horn works. The horn fuse may be blown. To
replace the fuse, see Fuses and Circuit Breakers on page 5-85.
If the alarm does not sound or the headlamps do not flash, the
vehicle should be serviced by your dealer.
0helpful
1answer

Horn doest work

the horn have fuse and relay in engine fuse compartment.inspect all the fuses. in your owners manual is the location of the fuse and relay. if OK, one person push the horn and other check power to the horn.if no power swap the relay with other one for test.if you SRS light is ON and the horn does't work suspect the clock spring(soft connection below the steering wheel to column)
good luck
0helpful
1answer

Hi just got 2001 daewoo leganza. test drove good paid cash get home ate lunch and went out to start the car and it cranked but would not start and run. also noticed door locks lights and windshield wipers...

Still check the voltage if it is below 12.7volts. It may be too low to have the car started. It is odd that the other electrical does not work. You may have to inspect all of the fuses then. If the fuses check out OK you may have to inspect the wiring. Check the wiring. After the battery the power cable should go to the boxes for the fuses, the relays, etc. Inspect the terminals there up to the inside. There may be some ground wires that are not connected or insulation or wires that may have gone bad.
5helpful
1answer

I have a 98 Nissan altima gxe and my alarm won't honk when I lock the car but the lights go off when I lock it and Wen I take the alarm off no honk or lights go off Wat can I do

holdboth the lock and unlosk buttons on your remote simultaneously for about five seconds until the lights flash and horn chirps.that should do it.if not i believe these models used a separate horn for security system.possibly fuse for this horn is bad or the horn itself is bad.to see if this horn works lower drivers window.stand outside vehicle and lock doors with remote.wait about a minute and reach in window and MANUALLY unlock and open door(do not use power door lock button)this should cause the system to activate...horn should beep and headlamps should flash.if horn beeps try my first suggestion.if it doesnt beep and just the head lamps flash check fuses and horn for security system.
4helpful
2answers

I bypassed the security system the car still want start I placed a hot wire directly on starter and the car turned over but there was no fuel going up what is the problem now

Try hooking the security system up again so that it's functional, then take out the fuse that's located on the fuse box in the trunk that's associated with the security system. It should be labeled "theft" and it's a 10amp fuse. The system will still function as normal only the horn will not sound if the security system is tripped and it will not shut down the fuel pump.
0helpful
1answer

My 04 bmw ignition doest start

If it doesnot crank at all look for starter/starter relay/starter relay fuse. Most probably wiring coming to starter is loose, try to tighten it more (push towards starter). Also I would check antiteft system (if it is provided for your car) as some BMW have immobilizers.
If it cranks no start look for spark plugs, wires, distributor cap, coolant temperature sensor, O2 sensor, fueling system (fuel pump cutoof switch, fule pump relay, fuel filter).
Please kindly let me know if you need more information, or kindly provide me with more details to assist you better
Good Luck
Not finding what you are looking for?

757 views

Ask a Question

Usually answered in minutes!

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...