SOURCE: engine removal out of a 2000 chevy blazer 4x4
hi everything is easy if you know what you are doing and have the right equipment so have you got lifting gear have you got a good selection of tools and will need a little help getting the engine in and out otherwise you will struggle and you need to be inside with plenty of space good luck, yates210456
SOURCE: 2000 Chevy Blazer
i am working on a s 10 of the same yaer and problem i will post my results after tomorrow when i have finished the job i bout this truck cause of the forum i own one that is a great one and this one is for experimental purpose i will let u know so far you cant lift the motor with a jack or a hoist so we r going another route in the mornin
SOURCE: 2000 Chevy Blazer Computer/Brain Location
It is mounted on the RH inner fender under the hood. It's a black metal box with fins on it and a few large wiring harnesses going into it. You MUST have the battery disconnected when you hook the new one. Good luck
SOURCE: Airbag removal 2000 Chevy Blazer 4.3l
there should be 2 or 4 bolts/screws on the back of the steering wheel
SOURCE: replace lower ball joints on a 2000 chevy blazer 4
Raise vehicle up on jack stands so that the stands are under the lower controll arms and the suspension is "loaded" Remove the front tire(s) (if you break the torque on the nuts while the wheel is still on the ground it helps, but do not loosen them completely as you will be looking for new rims and wheel studs too). Place a drift or some other suitable object in one of the brake rotor vanes so that it will hit the brake caliper and stop the rotor from moving and remove the CV shaft nut (it's a big ****** make sure you have the right socket on hand before getting to this point). Next remove the brake caliper and rotor then undo the wheel bearing retaining bolts and remove the wheel bearing. This should give you enough room to move the axle shaft back and up so you can work on the ball joint. If you've had ball joints replaced before just unbolt the ones that are installed and using a pickle fork, or a block of wood and a hammer, drive the ball joint stud from the knuckle. (make sure to support the upper control arm so it doesn't drop down on you when you do this) If you are working on original ball joints then I reccomend placing a block of wood or something else that will protect the cv boots from drill bits ect and drill out the rivets holding the ball joint in place. then remove in the same manner indicated in the previous paragraph. installation is pretty much the reverse of removal and don't forget to torque your cv shaft nut I have a 1999 and the manual specs 103FTlbs... This is a critical torque as it helps preload your wheel bearing. Too high and you'll burn them up, too low and they'll be loose and wear out.
Testimonial: "Thank you for your directions this will help very much."
488 views
Usually answered in minutes!
×