2007 Jeep Commander Check engine light is on (but that has been on for awhile.) Electronic Throttle Control (ETC) warning light just came on and my temperature doesn't move very from C. Any ideas?

It is 'P-Zero' not 'P-letter o'.

Idle Air Control. Details in the link

https://www.google.com/search?q=2007+jeep+commander+P0507&

..

Here are a couple of web sites to check their content and see if their information is able to help you in your task to relearn your throttle body. Hope they help .

https://www.youtube.com/watch?v=ttZZSN8gEo8

https://www.jeeppatriot.com/forum/15-engine-drivetrain/262473-relearn-procedure-throttle-body-replacement.html

Doesn't have one , has ETC - electronic throttle control .


Electronic Throttle Control ETC System

That light is the Electronic Throttle Control Light or ETC Light. When this light is on it is warning you that there is a potential concern with the throttle control. It is best to get the vehicle to an Authorized Dealer at your earliest convenience. However if the light is on and flashing you may experience a racing/rough idle or engine stalling and your vehicle may require a tow. In this case get your vehicle to an Authorized Dealer right away.

This is a warning that something needs to be checked. This happens a lot when a vehicle is jumped with a dead battery. You may have to take to dealer and have ETC reprogramed.
Throttle Control Warning Light More and more vehicles are doing away with the mechanical throttle cable between the driver's foot and the engine throttle body, replacing it with a "drive-by-wire" system. In this system, a throttle pedal sensor sends data to an electronic throttle control computer, which evaluates and relays the throttle request to a specialized electronic throttle motor on the engine throttle body.
The throttle motor opens or closes the actual throttle blade, which increases or decreases the power output of the engine. The throttle control warning light illuminates when a problem is detected in the electronic throttle system.

scan it yet. use a real scan tool and scan.
and report DTC;
OR SCAN IT AND READ THE FSm
IT WILL SHOW YOU HAVE IT WORKS.

Have you had the engine computer checked for trouble codes ?

have the fault codes read and replace the faulty units. Ask the service person if they pressure cleaned the engine as that quite often causes problems with water getting into the connections and shorting out

yeah i tried all those yaw said and nothing happend lol i thinks mine the etc bcse it runs rounge sometimes acting like a coil pack but it dsnt misfire or have bad gasmilege and it picks up and goes sometimes while its doing this

Hi where is the throttle control located in a 2007 jeep laredo diesel 3,0 liter not sure where it is can somebody help thanks