Cars & Trucks Logo

Related Topics:

B
Billie Waller Posted on Mar 27, 2017

2004 Ford Ranger 10 amp fuse keeps blowing no brake lights,abs, turn signals?

1 Answer

Dave Bamber

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 10 Answers
  • Posted on Mar 27, 2017
Dave Bamber
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Nov 27, 2012
Answers
10
Questions
2
Helped
7280
Points
39

Fuses blow because there is an overload on the system. If the fuse blows when you step on the brakes then there may be a short in the wiring from the brake light switch to the lights, abs module or turn signal switch. If the fuse blows when you turn the key on then there is likely a short in the wiring to the brake light switch. Basically you will need a wiring schematic to check the wires at the switch and at each of the loads. Also verify that the fuse is supposed to be a 10 amp fuse. Hope this helps

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Brack lights wont light up on my 1988 ford ranger we keep blowing fuse and put in new brake switch

If you keep blowing the brake fuse than you have a short in the system. Unplug the brake switch. Install a new fuse. If it did not blow than the problem is after the brake switch. Next unplug the turn signal switch, then plug the stop light switch back in and press the brake pedal. Did the fuse blow. If not than the wiring is good in between the two switches. With the turn signal switch disconnected use a jumper wire in between the light green wire (power from the brake switch) and the orange with light blue wire (power to the right brake lamp). If the fuse blows than there is a short in the right side brake circuit between the plug in and the rear socket assembly. If the fuse does not blow than jump from the light green wire to the Light green with orange wire (power to the left brake lamp). If the fuse blows than the problem is in the left hand brake wiring circuit.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

0helpful
1answer

Blowing fuses when i put my ford ranger in gear

short circuit in the multi function switch in the column.
1helpful
1answer

My 2008 Ford Ranger keeps blowing the fuse for the brake lights and turn signals. Where should I start looking for the problem?

check if you are using the right fuse for one and then check your wires for nicks or any thing that doesnt look natural for a wire
0helpful
1answer

2004 ford ranger when brakes applied makes sound like a pump running ABS and BRAKE indicator lights are on.

the sound u hear is the abs pump.for the lights to be on and hear the pump running, there is a problem, take it to shop before brakes fail completely
0helpful
1answer

In my 95 ford ranger i keep blowing fuse 13 and maxi fuse 8. I have no brake lights or turn signals.

Check the wiring where it connects to the socket for the bulbs in the brake lens and front turn singals
0helpful
1answer

The left turn signal stopped working, then the right. Now the blower and the abs light is on. I changed the turn signal switch/hazzerd/wipers. And the 10 amp fuse keeps blowing. Marked turn/bu/abs

20amp turn on four ways and parking lights go around replace any bad bulbs turn of for ways tern key on tern right tern on go around se if blinking tern on left and se if not chang flash thears 2 flashers switch the tow to se witch is bade.chek fuse for the right amp look inside fuse cover for right amp
70helpful
5answers

Diagram of 1996 ford ranger fusebox which fuse is

RANGER FUSE PANEL Fuse Position Rating Circuit Protected 1 7.5 Amp Power Mirror 2 — Not Used 3 15 Amp Parking Lamps 4 10 Amp Left Headlamp 5 10 Amp On Board Diagnostic (OBD) II System 6 7.5 Amp Air Bag System/Blower Relay 7 7.5 Amp Illumination Switches 8 10 Amp Right Headlamp/Fog Lamp System 9 10 Amp ABS System 10 7.5 Amp Speed Control/GEM System/Brake Interlock 11 7.5 Amp Warning Lamps 12 10 Amp Front Washer System 13 15 Amp PCM System/Stoplamps/
4WD/ABS/Speed Control 14 10/20 Amp ABS System 15 7.5 Amp Air Bag System/Alternator 16 30 Amp Front Wiper 17 15 Amp Cigar Lighter 18 15 Amp A/C System 19 25 Amp Ignition Coil/PCM System 20 7.5 Amp Radio/GEM System/Anti-Theft 21 15 Amp Hazard Lamps 22 10 Amp Turn Signals 23 — Not Used 24 10 Amp Starter Relay/Anti-Theft 25 7.5 Amp Speedometer/GEM System 26 10 Amp 4R44E/4R55E Trans./Backup Lamps/DRL System 27 10 Amp Underhood LP/Map Lights/Glove Box Lamp/Dome Lamp/Visor Lamps/4x4 Sys. 28 7.5 Amp GEM System 29 10 Amp Audio System 30 — Not Used 31 — Not Used 32 — Not Used 33 15 Amp High Beam Lamps 34 — Not Used 6d47eae.gif
0helpful
1answer

2006 f150 keeps blowing turn signal fuse

It sounds like the fuse is doing what it is supposed to do, and burning out when there is a short circuit. Check the wiring from the fuse block back to the lights and pay special attention to the trailer connection.
1helpful
1answer

2006 Ford Ranger. Rear passenger side tail light

Bad earth connection.Clean or replce wire.
1helpful
1answer

94 ford ranger blowing fuses when i turn on headlights

I would check the trailer light wiring to make sure it doesnt have any wires that are exposed or touching metal.Odds are that is what is causing the fuse to blow
Not finding what you are looking for?

1,260 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...