2005 Dodge Neon SXT error code P0700

Dodge Neon Questions - 04 neon will not go into high gear ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusNov 3, 2012 - 04 neon will not go into high gear - 04 neon won't go into high gear. changed transmission fluid. (it tried to change after fluid was changed) gas cap ... ... Car: 2003 Dodge Neon SXT, automatic transmission. As of today, I have ...

Dodge Neon Questions - 2005 Dodge neon does not shift ...

www.cargurus.com > Questions > Dodge > Neon

CarGurusApr 6, 2014 - Your cars computer gathers info on speed in order to shift gears properly.... then you won't have a speedo and the ECM will not tell the TCM to shift gears in the trans. .... Car: 2003 Dodge Neon SXT, automatic transmission.

Neon wont shift out of first gear auto. - DodgeTalk : Dodge Car ...

www.dodgetalk.com > ... > Dodge Neon - General Talk

Jul 30, 2011 - I have a 2003 dodge neon se and it will run and drive. The transmissonwill not shift out of first gear. Where do I start? Compare to Toyota Tundra. Get Tundra on ... 2000 Stratus won't shift out of First Gear
Mar 14, 2007
Not shifting out of Second Gear???
Jan 15, 2007
46RE wont shift out of first at full throttle.
Nov 17, 2006
Transmission wont shift
Nov 3, 2005
More results from www.dodgetalk.com

BAD COMPRESSION CHECK COMPRESSION ON ALL CYLINDERS

P0010 code is the camshaft position sensor. If this fails the vehicle will simply shut off.

P0315 - Crankshaft Position System Variation Not Learned
P0335 - Magnetic Crankshaft Position Sensor Electrical Error China OBD2 car diagnostic tools wholesale on CareUCar

Hi
That is the 'ambient temp sensor high' code.
Read this: LINK

Td

Is it the 2.0? I have some codes for the 2.0. I had one! Fun to drive but always in the shop. Here is what i found...
p0175 - System too rich (bank 2)
p0700 - Transmission control system mil request
p0731 - First gear incorrect ratio

I hope this stuff helps!

I have Dodge caravan 2010 and my falfunction light is on,what do i do?

check to see if your tentioner spring loaded pulley is operating properly.
i.e. you can move it with hand pressure it can be to hard to move or too easy.
both can cause this problem. loosen or tighten the retainer bolt.

The codes listed all point to the transmission being in bad shape or some wiring got crossed. Check with a trans shop for an estimate.

P0700 is EATX code present. It simply means that the engine computer has noticed that the transmission computer has a dtc in it. This causes the Pcm (engine computer) to turn the check engine light on. You will need to have the TCM (trans computer) checked for codes to know what to diagnose.

error code P1776 - Replace rear solenoid switch

Likely both related The P1776 probably kicked off the P0700 notification.

Hope that helps! Happy Motoring!