SOURCE: removing idler arms for a 1989 chevy astro van
are you try to remove the tapered end that connected to the steering linkage ? if you are you will need a pickle fork, some part stores will rent this tool to you good luck kdc744
SOURCE: 2003 Astro van - power locks & AC issues...
There is a vacuum line that goes from the vacuum reservoir (usually next to the bottom of the passenger side engine) up and across the top of the engine to connect on the driver side of the engine. The vaccum line cracks/leeaks and will not allow the vent vacuum actuators to function. Replace the line. Use a thicker wall buts same inside diameter rubber vaccuum hose. Probably under $5. People waste a bunch of time replacing the actuators, switches, etc. Its just the vacuum line and poor original placement/design.
SOURCE: 94 astro van drivers door will not unlock with key
are you sure its locked? could be the latch is frozen. try pulling the door handle open, and pounding on the door from the inside
SOURCE: repl door handle on 1999 chevy astro van right
should be a rubber plug on the end of the door
SOURCE: having problems with my Astro 1994 van the sliding
Take screw driver while prying on the door handle push down on the latch.
To prevent damage to the vehicle, two people should perform this procedure.
Remove the interior trim panel.
Remove the bolt attaching the lower guide bracket and roller.
Remove the bolt attaching upper guide bracket and roller.
Remove the guide bracket and roller from the door.
Remove the hinge from the door.
Remove the door from the vehicle.
To install:
Position the door on the vehicle.
Install the hinge from the door.
Install the guide bracket and roller on the door.
Install the bolt attaching upper guide bracket and roller.
Install the bolt attaching the lower guide bracket and roller.
Tighten bolts to 89-124 inch lbs. (10-14 Nm).
Install the interior trim panel.
430 views
Usually answered in minutes!
×