SOURCE: Mazda mpv O2 sensor wires?
Put some penetrating oil on them and let it soak overnight. This will break up the rust and other build up. Make sure that it is penetrating oil, you can get it at any automotive store.
SOURCE: Need an ecu wiring diagram
what is the car doing?? by you saing "need a ECM diagram?" what is the problem with the car. that car is pretty bulletproof and I have't seen any ECM issues unless your A/C drain is clogged up and water leaked onto/into your ECM frying it up. Let me know what your symptoms are.
SOURCE: 1998 rav 4 ecu pinout location
It is the Violet wire with Wht tracer (off of pin 9C) labeled SPD in the main ECM Engine Control Module.
Locate the E6 dark gray ECM 22 pin connector (two rows of 11 pins). The electornic signal you are looking for is on PIN9 be very careful.
Do Not use the ECM 26 pin or 16 pin connectors...just the 22 pin connector.
SOURCE: Where is the bank 2 o2 sensor located on a 2004
bank 2 is the cylinder in the front of the engine compartment near the radiator, the O2 is either in the exhaust manifold of the bank or in the exhaust pipe off the manifold, round about the size of a jumbo magic marker, you need a special O2 sensor socket to remove it in some cases, if it is in the open then a 7/8 open end wrench will work.
Testimonial: "Awesome response time, this was exactly the information I needed."
SOURCE: wire diagram for 2005 mazda mpv
simple cost not much go to autozone or advance part store the have radio plug kit for after market radios under 12 dollars
134 views
Usually answered in minutes!
×