TRY:
http://www.autopartswarehouse.com/vehicle/2001/ford/crown_victoria/base/8_cyl_4-dot-6l.html
SOURCE: massive tune up for a 2000 crown victory
Plugs, Direct ignition modules should be checked for conductivity and resistance,oil, oil filter, 14 quarts of tranny fluid, tranny filter,oil, oil filter, serpentine belt, tensioner pulley setup ( cops beat on these motors) fuel filter, flush the coolant system ( a new radiator is great for these cars), timing belt, purple oil for the rear end, Id either ad Lucas (my first chioce) or marvel mystery oil for the motor, tranny, and rear end, as long as there isnt any serious trouble mechanicaly this will condtion the moving parts and reduce breakdown of those partts. Other than that i think you'd be wasting money, i work at a dealer that specializes in goverment cars, ive seen theese steps bring a car that wont move and barely run, to a dependable daily driver. good luck
SOURCE: Rusted rocker panels. looking for lower
Hi, you can contact car body parts on 1-888-251-1209, 1-800-813-5686 to request for the parts...
SOURCE: Will 1997 mercury grand marquee rocker panels fit my 2003 ford crown vic
if it is the same heads then yes.
Fig. 2: Rocker arm assembly - 5.0L and 5.8L engines
* Apply engine oil or assembly lubricant to the valve stem tip and
pushrod end. Also apply lubricant to the rocker arm and fulcrum seat
contact surfaces.
* Rotate the crankshaft until the lifter is on the camshaft base
circle (all the way down) and install the rocker, fulcrum seat and
fulcrum bolt. Tighten the bolts to 18-25 ft. lbs. (24-34 Nm).
* Install the rocker arm cover(s).
209 views
Usually answered in minutes!
×