It'd be down low, near the rear of the engine. Follow the positive battery cable to it's end- the cable attaches to the starter.
Its gonna be on the back of the engine usually attached to the transmission. I believe this year its on the right side and I believe that its lower so you have to jack the car up
I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_677dced97ad9bddf
SOURCE: Starter issues
passenger side of the engine 2 bolts going up vertically hold it in place. un hook the battery before you do anything. hope this helps mike
SOURCE: where is the knock sensor located on the 3.8
under the engine right next to the starter, like the rear of the starter
SOURCE: where is the starter located
UNDERNEATH THE CAR IN THE FRONT OF THE CAR IN FRONT OF THE TRANSMISSION
SOURCE: replace door skin on 1996 camaro
I see this was asked years ago but never answered. So for the future questions about this,
The doors and roof panels on 4th Gen F-bodies are SMC (Sheet Molded Compound), a form of fiberglass. The skin is glued on. To remove a glued on panel use either a heat gun or a plumbers torch (Map Gas). Heating around the skin where the panel is bonded to the inner structure will break down the adhesive. Be careful not to burn the SMC away in a fire (heat guns are safer than the torch). Where you start, insert a putty knife to lightly pry the skin off as you heat the area.
310 views
Usually answered in minutes!
×