SOURCE: ticking sound in dash board everything else seems
THIS NOISE IS COMING FROM A DEFECTIVE AIR TEMPERATURE CONTREOL BLEND DOOR ACTUATOR GEAR DRIVE SLIPPING TEETH.
SOURCE: Were is the crank shaft position sencor located on
The crankshaft sensor shoul or is located at front of engine bolted to the block . It senses the crank position so it is mounted where it can ,in close proximity of the pulley. Ned
SOURCE: I need help finding crank
The Crank position sensor is located on the drivers side front of the engine below the AC compressor and picks up its signal from the front crankshaft pulley trigger ring. In the picture below is a technican grasping the connection to the sensor and the sensor directly in front of the connector.
SOURCE: how do i replace the
CRANKSHAFT SENSOR LOCATED ON THE SIDE ENGINE BLOCK NEAR THE OIL PAN.JUST DISCONNECT ELECTRICAL CONNECTOR GOING TO SENSOR . AND REMOVE SMALL BOLT HOLDING IT IN PLACE THEN REMOVE SENSOR.
129 views
Usually answered in minutes!
×