Nissan maxima 2000 not moving when in drive D but can move in gear 1 or 2.

Phil Lovisek

• 726 Answers
• Posted on Aug 21, 2008

SOURCE: gear shift

Do you hear a clicking sound coming from the shifter area everytime you hit the brake pedal, while the vehicle is is "P" park position?? There should be a clicking sound right by the shifter. That's the shifter lock solenoid. If that's not clicking you will not get the car out of park. Let me know what you found.

SOURCE: My 2000 Buick Lesabre won't

This is caused by Worn out Clutches inside the Automatic Transmission. You will need a Rebuild on the Tranny. This will stop these Problems.

SOURCE: Maxima - terrible vibrations in low speed

A bad tire, a loose wheel, a loose tie rod end, a bent rim, (tire balance at higher speeds), a piece of rust or whatever caught between the rim and brake rotor, or between the brake rotor and hub. Have you done anything to it prior to this starting?

I had this issue and it was one of my winter tires about to blow out, showing signs of weakness.. hopefully this helps!

SOURCE: 95 maxima not moving after putting into gear

Sounds like you may want to check if one of your cv axles has popped out of the transmission(usually the driver's side because the right on is bolt into a support bracket).

SOURCE: transmition stuck in drive

sounds like shifter cable busted... pop the hood and look at drivers side, have another person move the shifter so you can locate the cable... then find the arm coming off the transmission move it all the way one direction it will be either park or low range and that should get you moving again...