SOURCE: Acura Legend Sedan 3.2 lts 1994
replace de ignition module first.. if still wont start good chances is the crank sensor is located behind the timing belt.. my 94 legend use to do the same thing until i replace the crank sensor.. and also if u can afford i will suggest u to replace the main fuel relay too... all this is after u are 100 pcnt sure that ur fuel pump is working....
SOURCE: Acura Legend 1994 fires, but won't start
'Fires' implies that you have spark and fuel; I think you mean that it cranks with the starter.
Checking these separately is not difficult, you need to remove one spark plug lead and insert a screwdriver, then position the wire and the 'extension' so that the shank of the screwdriver is close to, but not touching some metal related to ground. This is about any exposed metal on the engine.
When cranking, during each revolution you should see a healthy blue spark between 1/4" to as much as an inch.
This tells you that the system supplying the high voltage is at least working.
Of course that alone doesn't tell you that each plug is getting spark but to do that, you would need to remove each plug wire from the plug in succession and test them individually.
Generally, if you have a single failed plug wire or plug, the engine will start but miss noticeably and it isn't not likely that all plugs and wires fail at the same time.
Checking the fuel supply depends a little on the delivery system. I think your car does have fuel injection so look for a fuel 'rail' that runs parallel to the engine. This is a length of pipe to which the injectors are attached and delivers gas to them.
Most of the fuel rails will have a pressure relief valve on them that looks similar to a tire valve.
After cranking for a few seconds, depressing the center pin should result in gasoline squirting from it.
If it doesn't, you may have a failed fuel pump or a severely clogged inline filter. A bad fuel pump is more likely.
There are other points of failure such as a defective ignition switch but these will not normally fail instantly but become unreliable first.
When a recently run engine refuses to start, it is sometimes due to too much fuel in the cylinders (flooding) and this can cause plugs to fail to fire and can be alleviated by depressing the accelerator pedal completely to the floor and leaving it there; don't pump.
This causes more air to enter the engine without causing additional fuel to flow and will, after cranking for 30-60 seconds, dry the plugs out and allow them to fire again.
The fuel pump in your car may be fused so I would check the fuse box for any visibly blown fuses too.
SOURCE: change idler pulley
It's a T-40 size, but I removed the bolt by first removing the bracket holding the pulley--I assume you're talking about the alternator idler pulley, the one right below the alternator. The bracket is held in place by three 14 mm bolts which I was able to reach from the top of the engine (after removing the black plastic air tube). I then put the bracket in a vise and "buzzed" off the 14 mm nut using an electric impact wrench ($30 +/- from Heartland of America). Be careful when putting the nut back on--the impact wrench will likely be too much torque!
SOURCE: 1994 ACURA LEGEND RADIO CODE
i have a 1994 acura ledgend but i dont have the owners manuel that holds the code. how can i bypass or get it to work
SOURCE: 1994 Acura Legend check engine light is on. When
turn the ignition key to the acc or lock position with the odometer reading showing.
while holding the trip/reset button turn the ignition to the on position. light should flash and go out!
reset done. if you have any more issues plese ask. good luck
76 views
Usually answered in minutes!
×