At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You Changed a lot of parts but did not say weather or not the engine is firing or not. if its not, Take an extra spark plug. pull one of the wires from a cylinder and put the plug in it. lay it on the engine block or frame so the plug is touching metal. have someone crank the engine over and see if the plug has spark. This is the easy way if you don't have a tester. MAKE SURE you are NOT touching the plug or wire while cranking the engine over or it will give you one heck of a Shock.
These vehicles are notorious for having shared ground wires that crack or rot and give poor connection to the PCM (power control module)or one of its sensors.
Got a check engine light? Get the codes read to find out if the misfires are on all cylinders or just 1. Could be ign coil, bad crank or cam sensor, or a valve issue
The big rectangles are referencing the engine, the cylinder associated to it's "firing" are the colored circles, and the are also the location of the spark plugs....the smaller lego-looking block is your coil pack. The spark plug wires run from the coil pack to the spark plug on the engine. The wires match 1 to1 or black to black...and so on....
When these are matched to each cylinder/spark plug and it's wire leading to the matching coil pack position, this is it's "firing order". If one of the wires is "crossed" meaning, not 1 going to 1, then the engine will "miss-fire".
YOU NEED TO CHECK DARK GREEN/ORANGE WIRE AT IGNITION COIL WHEN CRANKING ENGINE FOR POWER..IF NO POWER,SHUTDOWN RELAY IS NOT BEING ENERGIZED..THIS ENGINE ALSO HAS CAMSHAFT POSITION SENSOR ON END OF CYLINDER HEAD..ENGINE CONTROLLER NEEDS CAM AND CRANK SIGNALS TO ENERGIZE THE SHUTDOWN RELAY..UNPLUG CRANK SENSOR AND CHECK VOLTAGE ON ORANGE WIRE..SHOULD HAVE APPROX 8V..IF NOT..UNPLUG CAM SENSOR AND SEE IF 8V SUPPLY RETURNS..IF NO POWER TRY UNPLUGGING VEHICLE SPEED SENSOR LOCATED IN TRANS HOUSING WHERE RIGHT SIDE AXLE COMES OUT OF TRANS..IF 8V RETURNS..THE SPEED SENSOR IS SHORTED INTERNALLY..THESE 3 SENSORS SHARE THE SAME 8V SUPPLY CIRCUIT..WITH SPEED SENSOR UNPLUGGED,PLUG CRANK SENSOR BACK IN AND TRY TO START ENGINE..HAVE SEEN THIS SAME PROBLEM AT WORK RECENTLY
it sounds like you may have the wires on the wrong coil. It should be #1 on the #4 coil, and the #3 wire on the #2 coil. you probably have them backwards so 1 and 3 are firing on the exhaust stroke. the firing order is 1-3-4-2. they should be hooked like this.
×