SOURCE: transmission filter on 2003 hyundia santa fe
In 2002 they discontinued the external trans filter. So your vehicle could have the external filter. If you look next to the trans dipstick tube, on top of the trans case you will see the filter or you will see just a spot where the filter use to go before they eliminated it. Yes, the filter does llok like a regular engine oil filter. If the trans does not have the external filter ontop then there is no service to the filter to be done, the only recommendation is to bring vehicle into a shop to have the fluid flushed. By the way, make SURE you use the correct Hyundai SP-III trans fluid (not dexron/mercon). This fluid is specific to the Hyundai and can not be purchased from auto parts stores, only the dealership. Failure to use SP-III will cause premature wear to the internal bands and clutches.
SOURCE: i need advice on installation of proportioning valves in 04 santa
this is simpler than i thought.you just remove the plastic air filter housing,in order to have room to work.to remove,loosen the hoses going in and outof the filter housing.next,open and remove the top of the housing,then remove the air filter.at the bottom of the bottom half of the filter housing are 3 bolts,remove these,and the bottom section will slide right out of the hose.using an 11 mm flare nut wrench,gently loosen the brake line from the bottom of the front proportioning valve.it is essential to be careful with this step,as the nut will strip easily.i cannot stress enough the importance of the flare wrench,as it has better contact with the head.next,take either an adjustable wrench,or a deep socket 22mm ratchet head,and loosen the valve.on removal,repeat these steps with the rear brake line and valve,then place the new valve,turning just until tight(overtightening can damage the valve).replace the brake line nut at the bottom of the new valve.repeat this on the front valve.after this is through bleed your brakes as you normally would when change the brake pads.have plenty of brake fluid available,as it will almost all drain out during replacement of valves.have a drip pan on the ground under the master cylinder before removal of any brake components.
SOURCE: please help with failure codes p0462 and p0183 on
p0462 means - fuel level sensor "A" circuit low.
p0183 means - fuel temperature sensor A circuit high.
try to check those sensor...
SOURCE: how to remove alternator on 2002 hyudai santa fe 4 cylinder
try these websites to see if they have your car listed www.autozone.com and the other one is www.alldatadiy.com and if all fails stop by your local library and get your hands on a Haynes auto repair manual for your car.
SOURCE: How to remove rear brake rotors
THE REAR BRAKE ROTOR IS A LOOSE ROTOR AND SHOULD COME OFF EASILY. IF NOT, IT IS POSSIBLE THAT THE ROTOR IS HELD BY RUST ONTO THE HUB OR THE BRAKE SHOES IS STILL EMBEDDED INTO THE ROTOR. REMOVE THE HANDBRAKE CABLE TO ENSURE THAT THE BRAKESHOES COLLAPSE AND TRY TO LOSEN IT AGAIN. IF SEASED ONTO THE HUB BY RUST, KNOCK THE ROTOR WITH A COPPER HAMMER TO BRAKE THE RUST WITH A RUST REMOVER.
518 views
Usually answered in minutes!
×