SOURCE: Won't shift out of park
check to make sure you have brake lights when trying to shift if not check the brake lamp switch if it is ok you might need a shift interlock solenoid
SOURCE: 2000 crown victoria -brake lites failed
You have a bad switch at the brake pedal. Or a loose wire. Try light pulling on the wires on the switch at the brake pedal under the dash. They should be tight and secure. If tight and secure the switch could be bad.
SOURCE: No tail lights or brake lights/must start car in neutral
Look up at the top of the brake pedal under dash and you should see a switch hooked to the pedal with a LG/R and LG wire. You should have power on the LG/R wire then when you depress pedal it should have power on the LG then.
Another question does the 3rd or high mount brake lamp illuminate when pedal is depressed?
SOURCE: No Brake Lights, unable to switch from park to drive
It is not the multifunction switch. The power feed goes thru the brake switch before the multi function. You have no power the the brake switch because your shift interlock is not allowing you to shift it. I'll look up the wiring diagram and repost with a solution.
SOURCE: 1998 Lincoln Town Car: No turn signals, 4 way flash, brake lights
If only your brake light in middle of rear window works then your other bulbs are bad. If brake lights all work in the back than bulbs are good. If you put turn signal on right or left and the bulbs light in front and back then you need to change multifunction light control box under dash. My understanding is it cost $600 new. So I would try used.
615 views
Usually answered in minutes!
×