SOURCE: 2001 chrysler concord 2.7 liter timing set
I have a similar problem. I just replaced the water pump and now the POS wont start. Like it is not getting fuel>
SOURCE: Where to put the timing marks on a 96' nissan 2.4 liter
the timing chain tensioner is hydraulic and either out of adjustment or defective. You need to remove the timing chain cover and reset the mechanical correlation between the crankshaft and the camshafts. also the other ignition time marks are on the crankshaft harmonic balancer and the cam cover. Do not crank the engine with the timing out of sequence or you'll destroy the engine.
SOURCE: 1995 Jeep Grand Cherokee 4.0l timing chain problems
each gear has a mark on it from the factory that line up with a corrrsponding mark on the engine some times they are hard to find but if you look hard enough you will find them they all must line up there is no margin for error or it will not start like now good luck Lindz
SOURCE: 1999 Ford Expedition 5.4L Timing chain setup
.
Remove the two bolts, the timing chain tensioner and tensioner arm.
NOTE: LH shown; RH similar.
Remove the bolts and the timing chain guides.
Installation
CAUTION: Do not compress the ratchet assembly. This will damage the ratchet assembly.
Compress the tensioner plunger, using an edge of a vise.
If the copper links are not visible, mark two links on one end and one link on the other end, and use as timing marks.
If removed, install LH and RH crankshaft sprockets.
Position the tensioner arms and tensioners, and install the bolts.
610 views
Usually answered in minutes!
×