SOURCE: The windows in the 95 oldsmobile cutlass ciera won't work at all
maybe the wire is severed where the door (drver dr) pivots. thats what was wrong with mine. there is a rubber boot with crinkles in it that hold all the wires together. you can also try replacing the switch board that controls the wndws on the drvr dr. hope that helps.
SOURCE: 1989 oldsmobile ciera no spark unit cranks fine good fuel presure
most common cause of no spark is the ignition module located under the coil
SOURCE: 96 Oldsmobile ciera runs great but dies randomly driving or idle
I would try replacing the ignition module located on the front of the engine where the plug wires connect.The ignition moduel is where the ignition coils them selves screw down to and a harnes plugs into.
SOURCE: My Oldsmobile Cutlass Ciera with the 2.5 will not stay running
Nissan240sxe could you please contact me. I have the same problem and am about at my wits end trying to figure out whats wrong assuming you figured out the solution. Email me at [email protected] Thanks.
Hello! I need the trouble code...The vehicle is an On Board Diagnostic 1 (OBD!)...You can not use a scanner on an OBD1...See drawing below of connector under the steering wheel...Short pins A to B...Turn on the key...Don't start the engine...Light on dash will flash the code ie...4 long blinks...pause... 1 short blink=code 41...each code, if more tan one, will flash 3 times...record the code # and send it to me and I'll fix the problem....codes are all two digit... guru...saailer
I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867
140 views
Usually answered in minutes!
×