I think that series uses a clutch position sensor, If so it should be up under the clutch pedal itself. Or it may be on the side of the clutch pedal away from the firewall.
SOURCE: fuel pump switch
also known as the inertia switch is located on the left kick panel area by the emergency brake pedal . 90 full size bronko .
J5
SOURCE: firing order for 1989 full size ford bronco 302
13726548 #1 cyl is front pass side and count to back 1234 are on pass side.5678 are on driver side.# 5 being front
SOURCE: 1989 Bronco starts but dies after a couple of seconds
try checking the thermostat control senser. it caused my bronco to start for a second and then die. after a while it would finally start and run for a while then die driving down the road. i changed the thermostat control senser and it fixed all problems of dieing
SOURCE: No power to fuel pump
Hi..my name is Keith..and the 2 things that i know of...that will not let power go to the fuel pump is 1..the fuel pump relay being bad..or 2..that something has tripped the Inertia Switch...and it needs resetting..i hope this will help
SOURCE: removing neutral safety switch
Check out the autozone website at autozone.com and register your vehicle. It is free and will give you access to an online repair manual for the vehicle. The steps for removing the neutral safety switch can be found there. Hope this helped. Best wishes.
78 views
Usually answered in minutes!
×