There are no knocks in engine and runs find
Knock sensor tells the engine computer when one or more of your engine's cylinders are "knocking", that is, exploding the air/fuel mixture in a way that delivers less power and can be damaging to the engine if prolonged. The computer uses this information to tune the engine so that it doesn't knock. If your knock sensor on Bank #1 is generating a low output voltage (perhaps under 0.5V), then it will trigger a P0327 DTC. This P0327 code may show up intermittently or the Service Engine light may be lit constantly. Other knock sensor related DTC codes include P0325, P0326, P0328, P0329, P0330, P0331, P0332, P0333, and P0334.
Read more at: https://www.obd-codes.com/p0327
SOURCE: knock sensor
The knock sensor threads into the side of the cylinder block.
INSTALLATION
The knock sensor threads into the side of the cylinder block in front of the starter.
SOURCE: 1996 Nissan Maxima 2.5 V6 Engine Knock sensor
The knock sensor is a major pain in the a..s to change I would suggest taking it to a reputable shop for a second opinion to see if they realy performed the work. Also with OBD11 (2) diagnostics if you have multiple misfires its not the wires its something else, also if you got a code for a misfire it would be specific as to which cylinder is misfiring. My best guess would be to get your coil checked.
Testimonial: "Excellent "
SOURCE: I have 1998 Nissan Frontier with an engine light
the PO 325 code is for VSS vichicle speed sensor and PO500 is for a knock sensor,so you will need to see what the new code is to be able to help you, the engine power manegment is controled by both get it scanned by autozone or the mechanic that did the work and see if it's the same code, if it is you may have a short or an ecm going bad. let us know what codes you find.
SOURCE: check engine light on
Diagnostic code produces P0420 catalyst system efficiency below threshold-Bank 1. Probable causes are listed as follows:
1-air leak in exhaust before rear 02 sensor, 3-Fuel system fault,
4-faulty catalytic converter.
SOURCE: Service soon light stays on.. had it checked at
no, 30 minutes labor--you can do it yourself. part is $30. You have 2 of them. 327 is for bank 1, which is the back bank by the firewall. see picture below (the picture is bank 2, but location is same on other side).
To replace the knock sensor:
A defective knock sensor may cause engine detonation or reduced spark advance and fuel economy. When a knock sensor is removed and replaced, the sensor must be tightened to its specified torque. If the knock sensor is installed tighter than it should be, it may become too sensitive and provide an excessively high voltage signal, resulting in more spark ****** than required. When the knock sensor is installed looser than it should be, the knock sensor signal will be lower than normal, resulting in engine detonation.
Testimonial: "Thanks that was very helpful."
1,478 views
Usually answered in minutes!
×