Here's a link to your vacuum diagram Christopher,it' the last one down,just enlarge to see better.
Repair Guides Vacuum Diagrams Vacuum Diagrams AutoZone com
SOURCE: vacuum line diagram 98 chev monte
No sticker on underside of hood or on rad support showing that?
SOURCE: Vacuum diagram of Mercedes 190D, 2,2
neto 190D: You are asking about a vacuum diaphragm?
I'm going to take a WAG.. Your engine won't shut
down with the key?
If so, he is the way you find out:
In your injection pump, the vacuum diaphragm which kills the engine is the one which has the fitting pointing parallel to the ground.
The vacuum line which serves it is a brown/blue
To check the system, first check for vacuum in the line. Run the engine for a minute or so. Cap off the brown/blue line.
Turn the ignition switch off and then with hose in hand, uncap it and you should hear a hissing sound. If you have a vacuum guage, obviously, use it for the test, you need a minimum of 10 inches to kill it.
To test the pump diaphragm, you can rig a vacuum line to a known vacuum source close to the main "T". Run the engine and with the line connected to the diaphragm, connect it to the good vacuum source, if it kill the engine, the diaphragm is good. If you have a hand vacuum pump it would be more ideal, because you could check the diaphragm for small leaks.
If the diaphragm is bad, it is easy to replace on the pump.
The shutoff diaphragm lists for $86.00
Is my shot in the dark correct?
Even though I am a Nissan Master tech, I also specialize in Mercedes-Benz and specifically Diesels, so if you need help, I'm here. I went through a few Mercedes Schools and have been swinging Iron in Mercedes since the 70's
I might be a little more informative than the public library.
SOURCE: Vacuum leak-P0171 2000 Toyota Echo. Need vacuum diagram
A P0171 code does not indicate a vacuum leak; it indicates a dirty mass air flow sensor. This device is located between the air filter box and the intake manifold. Locate it, unplug the wire harness, and remove the 2 screws that holds it onto the intake pipe. Look down inside th sensor, you will see 2 small wires, that are probably covered with fuzzy things...using a spray cleaner, such as brake cleaner, spray the 2 wires until they are clean and shiny. Do NOT use compressed air, that will damage the sensor. When it is clean; reinstall it and drive it. The computer will recognize the now clean sensor, and your troubles will be over.
SOURCE: Need the Vacuum Diagram for a 1988 Jeep Wrangler 4.2 liter
try chiltons I got the haynes and the diagram is too hard to follow
SOURCE: where is the oil pressure sending unit located on
Its in the rear/ top /center. Hidden alittle, you can get it out with a special socket and it's not hard to access.
VACUUM LINE DIAGRAMS
There
are few direct links showing exact vacuum line diagrams. I suggest you to refer
the direct links.
Click
the link below: -----
---------------
http://howtobyme.blogspot.in/2012/01/how-to-locate-vacuum-leak.html
-----------------
http://schematicsdiagram.blogspot.com/2011/12/vacuum-hose-routing-diagram-for-1995.html
------------
http://repairhelpcenter.blogspot.com/2011/11/vacuum-diagrams-for-audi-a4.html
--------------------
-------------
--------------
-------------
http://technoanswers.blogspot.com/2012/01/vacuum-diagram-for-isuzu.html
-------------
http://technoanswers.blogspot.in/2012/02/ford-4-wheel-drive-vacuum-solenoid.html
------------
These
will help.
Thanks.
824 views
Usually answered in minutes!
×