How do i remove the door panel on 2008 eclipse?

If you put the following phase in a search engine, it should pop up a site at another service that directly addresses your situation.

remove the back door panel on a 2008 mercury mariner

You may have to download and view the pictures in your Windows software or FastStone Image Viewer to see detail.

how to remove left front door panel of merc.2008 220cdi

the connection in the door take off inner door panel and tighten all wire connections

on the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge.You can then disconnected the rod from the back of the inside handle and replace. If it's the outside handle, remove the weather seal and remove the bolts holding the outer handle on

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to remove the bolts holding the outer door handle on

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Probably not. They would not make it that difficult.

There are 7 screws all together to remove the door pannel. First, you have to take off the hanlde for the door. the 2 plastic covers on the handle pop off revealing 2 screws on the top and bottom, remove those. then behind the the door handle on the inside, pull it as if you were to open it and there is a screw that you have to remove. Then there are 2 screws on either side of the door pannel, both are farily close to the top, remove those, and then its just a matter of popping the pannel off. start from the bottom, pop it off then slide it up. becarefull, after the door panel is free, there is a connection for the power doors and windows unhook that then the pannel will be free. after that the speaker will be right there and its common sense on removing that. good luck.

here is an on line manual
i hope this helps you
don't forget to rate....thanks ;-)