SOURCE: 2001 oldsmobile alero window off track,
first remove the door panel there are three screws that need to be removed first 2 under the inside door handle and 1 on the lower left hand side behind a reflector then pull off the panel it will be held on by push clips, once inside move the plastic weather bearrer to the side ,run the window half way down you should see 2 window holding brackets pull the window up so you can drop it in the brackets, first get some black window adhesive fill the brackets with adhesive put window in brackets and roll it up and leave it up for 24 hrs.If the brackets are broken you will have to replace the whole window motor assemly which you can get on line for 89.00 not the 250.00 at dealer and you can install it yourself its easy to do.
SOURCE: Driver side window won't raise up!
Hi
Thanks for using FixYa. To resolve the issue you are facing with push the unlock button once on the factory remote=unlock all 4 doors. Hit unlock a second time=all four windows down. When exiting vehicle hit the lock button on remote=all 4 windows all the way up. Also, all four window controls on the driver’s door panel are one touch up and down on master window switch. Remove the door panel by prying it off. But be careful not to damage the panel. Now unscrew the top of the panel and the area by the arm rest. Once you get the panel off, then you will see how the switch is mounted into the door panel from inside. If the switch has gone bad this is required to be replaced. Remove the old switch and connect the new one.
Please do rate the solution and revert for further assistance.
Thanks
Rylee
SOURCE: driver side sun visor falls down
If you have anything on top of the visor, remove it. If there are any screws visible near the pivot rod, tighten them. You can remove the visor and slightly bend the pivot rod, inside the visor. You can just buy a new one and replace it yourself. It's only a few screws.
SOURCE: Drivers side window has slipped off track 2006 mazda mpv
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you can readjust the window mechanics.
SOURCE: my driver side window has come off its track on a
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you'll be able to get to the tracks. You may need to get some replacement clips to remount the window to the track
Testimonial: "Thank you for your quick response this was great information for fixing the window"
143 views
Usually answered in minutes!
×