Arm Rest on drivers side ''99'' Cherokee

Hi Konakalela, I'm Al the owner of Big As Auto Repair
Most arm rest have a round trim cover on the side of the seat that's removable. Simple remove that cover and there is a bolt behind it that holds the arm rest remove it counter-clock-wise and pull the arm rest straight outward. For further assistance go to my website. Have an awesome day Konakalela.
Auto Repair

There are two screws on either side of the armrest. Remove with Allen wrench or Phillips head. Be sure the armrest is closed position. After removing screws lift straight up to remove the armrest. Save the screws.

Hi Denise, I'm glad to help!

If the dealer doesn't carry them anymore then you'll need to contact some junk yards. Hope this helps and have an awesome day Denise.

using a flat blade tool like a small flat blade screwdriver, release retaining clip on arm rest and pull armrest from seat. slip the screwdriver between seat back and armrest and pry up on the retaining clip.

Un zip the cover on the armrest and pull it up to expose the bolt hole. unbolt and remove the arm rest and see what parts are damaged, sometimes it can just be tightened.

The armrests have covers that can be removed. Locate the zipper on the arm rest. Once you unzip it pull it toward the back of the arm rest and this will expose the one bolt that hold the armrest on. You will need a large torx and rachet to get it off. Once you take out that bolt the armrest will come right off.

usually there is some sort of plug youll have to pop out with a flat head screwdriver then more than likely a large phillips screwdriver to take out the screws which are in deep,hope this helps but cant really picture an armrest in back of mazda

There are a few screws that you have probaby missed inside the arm rest, underneath and on the end of the arm are lights he screws can only be accessed after you remome these light assemblies in the arm rest carfully pry the lamp assembly loose using a small screw driver or similiary tool and then you can reach the screws and remove the arm rest

Ahh, I'm in UK too.

Most interior panels are held on with screws at the armrests, any fittings points (handles,buttons, speakers etc.) and the rest of it is held in with plastic panel clips.

The best way to diy remove these is to use two steel rulers - one either side of the clips, and lever them off one by one.
Expect a few to break - they are replacable items.
Once inside, make sure you replace any plastic membrane, as this stops wind, and prevents corrosion in winter.

Any other problems just ask.

If this helps, please rate as fixya!
Thanks.